Defect Engineering Stabilized AgSbTe2 with High Thermoelectric Performance
Yu Zhang,Zhi Li,Saurabh Singh,Amin Nozariasbmarz,Wenjie Li,Aziz Genç,Yi Xia,Luyao Zheng,Seng Huat Lee,Sumanta Kumar Karan,Na Liu,Sanghadasa Mf Mohan,Zhiqiang Mao,Andreu Cabot,Christopher Wolverton,Bed Poudel,Shashank Priya,Gagan Goyal
DOI: https://doi.org/10.1002/adma.202208994
IF: 29.4
2022-12-26
Advanced Materials
Abstract:Thermoelectric (TE) generators enable the direct and reversible conversion between heat and electricity, providing applications in both refrigeration and power generation. The grand challenge in the field is related to the low conversion efficiency of TE devices. In the last decade, several TE materials with relatively high figures of merit (zT) have been reported in low‐ and high‐temperature regimes. However, there is an urgent demand for high‐performance TE materials working in the mid‐temperature range (400‐700 K). Herein, p‐type AgSbTe2 materials stabilized with S and Se co‐doping are demonstrated to exhibit an outstanding maximum figure of merit (zTmax) of 2.3 at 673 K and an average figure of merit (zTave) of 1.59 over the wide temperature range of 300 – 673 K. This exceptional performance arises from an enhanced carrier density resulting from a higher concentration of silver vacancies, a vastly improved Seebeck coefficient enabled by the flattening of the valence band maximum and the inhibited formation of n‐type Ag2Te, and a highly improved stability beyond 673 K. The optimized material is used to fabricate a single‐leg device with efficiencies of up to 13.3% and an unicouple TE device reaching energy conversion efficiencies up to 12.3% at a temperature difference of 370 K. These results highlight an effective strategy to engineer high‐performance TE material for cost‐effective waste heat recovery in the mid‐temperature range. This article is protected by copyright. All rights reserved
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology