Abstract:This article investigates the performance of finite element model updating to identify the induced damage in a two-story reinforced concrete masonry-infilled building using vibration data as well as lidar (light detection and ranging) scans. The building, located in El Centro, California, was severely damaged due to the 2010 El Mayor–Cucapah (Baja California, Mexico) Earthquake, and it was planned to be demolished following a number of ambient and forced vibration tests. The forced vibration tests were performed using an eccentric mass shaker. During the testing sequence, damage was induced to the building by removing four exterior walls. The modal parameters of the structure are estimated using the ambient vibration and forced vibration measurements at the reference state and damaged state. Lidar data are also used to detect surface defects and quantify the temporal changes of surface defects caused by the wall removal and forced vibration tests. Based on site inspections, geometry measurements, and material test data, two initial finite element models are built, namely the un-tuned initial model and the tuned initial model. The tuned initial model implements stiffness reduction factors to account for the observed damage in the building at its reference state while the un-tuned model does not. Two sets of reference models are calibrated to represent the structure at the reference state using the un-tuned and tuned initial models. The reference models are then updated to fit the measured data at the damaged state of the building with damage being estimated as the loss of stiffness in updating substructures. The estimated damage is compared to the nominal value of induced damage and surface defects detected by lidar scans. The analysis of the results indicates that the un-tuned and tuned initial models provide similar updated models and damage identification results which are in good agreement with the nominal values of damage and lidar detection results.

Programmatic model updating of damaged structures using modified SERR method

Automated Finite Element Modeling and Analysis of Cracked Reinforced Concrete Beams from Three Dimensional Point Cloud

IFC‐based Semantic Modeling of Damaged RC Beams Using 3D Point Clouds

INCORPORATING PRE-EXISTING CRACKS IN STRUCTURAL ASSESSMENT OF RC STRUCTURES

Estimation of Load-Carrying Capacity of Cracked RC Beams Using 3D Digital Twin Model Integrated with Point Clouds and Images

Nonlinear finite element model updating with a decentralized approach

Structural performance assessment of RC flexural members through crack-based fibre beam-column model updating

A Substructure-based Model Updating Method to Damage Detection for Large-scale Structures

DAMAGE IDENTIFICATION OF CIVIL STRUCTURES BASED ON FINITE ELEMENT MODEL UPDATING

Damage Detection and Rehabilitation on A Curvilinear Steel Box Girder Bridge by Multistage Model Updating

Multi-Scale Analysis Of Damage Process For Concrete Structures

Data-driven Corrosion Failure Probabilistic Assessment Model for Reinforced Concrete Structures

Computer-Vision and Machine-Learning-Based Seismic Damage Assessment of Reinforced Concrete Structures

Spatial Variability-Based Corrosion Risk Assessment and Strategy of Repair and Maintenance for RC Structures

Corrosion-crack path based probabilistic model to predict the durability behavior of RC components

An application of finite element model updating for damage assessment of a two-story reinforced concrete building and comparison with lidar

A Mesoscale Modelling Approach Coupling SBFEM, Continuous Damage Phase-Field Model and Discrete Cohesive Crack Model for Concrete Fracture

Vibration-based Bayesian model updating of an actual steel truss bridge subjected to incremental damage

Updating deterioration models of reinforced concrete structures in carbonation environment using in-situ inspection data

Experimental validation of an efficient strategy for FE model updating and damage identification in tubular structures

Structural damage identification via physics-guided machine learning: a methodology integrating pattern recognition with finite element model updating