Abstract:This study presents a novel roller piston pump,in which a cam guide-roller type rolling support is adopted to replace the sliding pair support of the swash plate-slipper pair to achieve the oil suction and discharge of the piston cavity.In addition,the shaft distribution is used to replace the original valve plate distribution and the driving shaft is used as the distribution shaft to remove the valve plate structure,which greatly simplifies the design of the axial piston pump.Such a configuration largely reduces the number of sliding friction pairs of the pump,and avoids the influence of the sliding friction pair on it under high-speed and variable-speed conditions.Firstly,mathematical models of the mechanical and volumetric efficiencies of the roller pump are deduced respectively through force analysis and the compressibility equation.Based on the numerical simulation of MATLAB and AMESim,the effects of load pressure and rotational speed on mechanical and volumetric efficiencies are studied respectively,and it is verified that the roller pump has no structural flow pulsation.The prototype pump is then designed and built,along with a special test rig.The outlet pressure,outlet flow,and torque of the pump under different load pressures and rotational speeds are measured,and the mechanical and volumetric efficiencies of the prototype pump under various load pressures and rotational speeds are obtained.The experimental results are in good agreement with the simulated analysis.When the load pressure is 8 MPa and the speed is 5000 r/min,the mechanical and the volumetric efficiencies are 85.5%and 96.8%,respectively.When the speed is increased to 10000 r/min,the mechanical and the volumetric efficiencies are 66.7%and 95.6%,respectively.The experimental results show that the proposed roller piston pump has excellent efficiency under wide-speed and high-speed conditions and can be a potential solution as a fuel pump in aerospace fuel systems.

Piston type gas flow rate standard device

Piston type gas-liquid dual-purpose micro-flow standard device

Development of a reciprocating double-pistons gas prover

Leakage Model of Distributing Mechanism in Fuel Piston Pump

New Distributing Mechanism for High Speed Single-Piston Axial Piston Pump

Modelling and Experiment Study on Fluid Character of Axial Piston Pump

Design and Simulation of a High Pressure Proportional Pneumatic Pressure Reducing Valve

Research on unsteady flow measurement standard device based on active piston

Gas Flow Calibration Standard Device for Working Site

Flow characteristics simulation and low-noise design of fuel piston pump

Study on Friction Characteristics of Slipper Pair of Large Displacement High-Pressure Piston Pump

Real-time Measurement on Lubrication Characteristic Parameters of Plane Port Pair in Axial Piston Pumps

Automatic Piston-Type Flow Standard Device Calibration System

Development and Application of Multi-Component Dynamic Gas Distribution Instrument Based on Mass Flow Controller

Study on Steady Flow Structure of Gas Flow Standard Device

Piston-Cylinder Assembly Design of the Digital Piston Pressure Gauge

Investigation of Test Principle of Flow Ripple Generated by Piston Pump with Complicated Pipe

A Test System for Super-long-stroke Hydraulic Cylinders

Theoretical and Experimental Investigation on the Efficiency of a Novel Roller Piston Pump

Flow sensor device

Online Measurement of Gas and Liquid Flow Rate in Wet Gas Through One V-Cone Throttle Device