Abstract:As turbine inlet temperature gets higher and higher, thermal barrier coating (TBC) is more and more widely used in turbine blades. For turbine blades with TBC, it is of great significance to evaluate the temperature distribution of its substrate metal quickly and accurately, especially during the design stage. With different degrees of simplification such as whether to consider the change of the geometric size of the fluid domain by TBC and whether to consider the planar heat conduction in TBC, three different methods used in conjugate heat transfer (CHT) simulation to model the TBC of the turbine blades have been developed and widely used by researchers. However, little research has been conducted to investigate the influence of the three methods on the temperature distribution of turbine blade. To fill this gap, three geometric models were designed. They are a solid conduction model with a substrate metal layer and a TBC layer, a transonic turbine vane with internal cooling and TBC, and a plate cylindrical film hole cooling model with TBC. Different methods were used in these geometric models and their differences were carefully analyzed and discussed. The result shows that for the conduction model used in this paper, with the same TBC surface temperature distribution, the difference between the three methods is very small and can be ignored. For a transonic turbine vane with internal cooling, regarding the local maximum temperature of the substrate-TBC interface, the largest difference between the method in which TBC is considered as a thermal resistance or a virtual layer of cells and the method in which three-dimensional heat conduction equation of TBC is solved occurs at the trailing edge. The difference near the leading edge is below 2 K. When employed to the film cooling model, the difference of the laterally averaged temperature of the substrate-TBC interface can be 8 K which is mainly due to the change of the length to diameter ratio of the film cooling hole by TBC. If the substrate thickness is reduced by the thickness of TBC when three-dimensional heat conduction equation of TBC is solved, the temperature difference between the three methods will be quite limited.

Thermo-mechanical analysis of TBC-film cooling system under high blowing ratio considering the effects of curvature

Thermo-Mechanical Coupling Computation and Warping Analysis During Controlled-Cooling of X65 Heavy Pipeline-Plate

Fracture Behavior of TBCs with Cooling Hole Structure under Cyclic Thermal Loadings

Numerical Stress Analysis of TBCs at Film Cooling Hole's Edge based on TBC-Film Cooling System

Comparative Study on Different Methods for Prediction of Thermal Insulation Performance of Thermal Barrier Coating Used on Turbine Blades

Thermal-Fluid-Solid Coupling Analysis on the Temperature and Thermal Stress Field of a Nickel-Base Superalloy Turbine Blade

Deformation Prediction Theory of Thermal Barrier Coatings near Cooling Holes under Thermal Cycling

The performance evaluation for thermal protection of turbine vane with film cooling and thermal barrier coating

Effects of thermal barrier coating thickness and surface roughness on cooling performance sensitivity of a turbine blade

Impact of Cooling with Thermal Barrier Coatings on Flow Passage in a Gas Turbine

Comprehensive Evaluation on Conjugate Heat Transfer and Thermal Stress Performance of Film Cooling

Interfacial peeling loads in the TBC with an air hole: Analytical solutions and viscoplasticity modelling

Simulation of Residual Stresses and Their Effects on Thermal Barrier Coating Systems Using Finite Element Method

Effect of Film Cooling Hole Geometry on Thermal Stress Based on Thermo-Solid Coupled Analysis

A total three-dimensional evaluation method to analyze the loss mechanism of film cooling on turbine guide vane

Buckle-driven Delamination of Thermal Barrier Coatings on a Polynomial Curved Substrate

Effects of viscosity and density on film cooling effectiveness of turbine blade with pressure gradient and surface curvature

Modeling 3D TGO dynamic growth and stresses and the resulting modes of buckling failure in thermal barrier coatings

Overall thermal performances of backward film cooling with simulated surface thermal barrier coatings at various walls

Performance and Failure Modes of Thermal Barrier Coatings Deposited by EB-PVD on Blades under Real Service Conditions in Gas Turbine

Computational analysis of thin coating layer failure using a cohesive model and gradient plasticity