Abstract:There is a vast amount of globally underutilized low-grade mine tailings and leach residues, including those from primary processing of gold. In this research, the target is to recover the remaining gold (10.9 g/t) from weathered refractory iron-rich residue that had previously been subject to autoclave oxidation, subsequent cyanidation in a conventional carbon-in-leach (CIL) circuit as well as storage at tailings area. Chloride leaching has been considered as one of the most promising cyanide-free gold leaching methods and it has shown positive outcomes in treating primary gold ores, concentrates, and flotation tailings. Therefore, in the current study, the iron-rich residue investigated was subjected to chloride leaching combined with simultaneous carbon adsorption. The investigated parameters included leaching time (2–8 h), chloride concentration ( [Cl − ] = 0.2–5 M), type and concentration of oxidant ( [Cu 2+ ]/[Fe 3+ ] = 0.1–1 M), as well as type and concentration of activated carbon (14–25 g/L), whereas S/L ratio (100 g/L), acidity ( pH = 1), and temperature (90 °C) were kept constant. Leaching results indicate that up to 40% of the remaining gold could still be recovered from the investigated residue with optimized chloride leaching. According to the results, the most important parameter for gold recovery was the leaching time. Moreover, of the studied oxidants, cupric ions were shown to contribute more to gold recovery when compared to ferric ions (35% vs. 24% at [Cu 2+ ]/[Fe 3+ ] = 0.1 M). Nevertheless, an increase of cupric concentration from 0.1 M (low-concentrated) to 0.5 M, resulted in only a slight increase in gold recovery (from 36% to 40%), whereas no further improvement in gold recovery was achieved with a 1 M cupric concentration. Two studied activated carbon products showed equal effectiveness in gold adsorption. In-situ carbon adsorption was shown to occur effectively in chloride media, as all dissolved gold could be detected in the activated carbon, and the concentration of remaining gold in the pregnant leach solution was minimal (< 0.02 mg/L). These findings indicate that low-concentrated chloride leaching of leach residues from industrial gold processes can allow an enhanced recovery of gold from previously mined and treated raw materials.

Accelerating gold extraction from refractory gold tailings via NH4HF2 pre-treatment

Mechanism of synergistic pretreatment with eco-friendly CaO and Na 2 CO 3 to enhance gold leaching efficiency from fine-disseminated gold ores

Enhanced Hydrometallurgical Pretreatment of Micro-disseminated Gold Ore

Study on uranium leaching from uranium purification residue with ammonium hydrogen fluoride

Pretreatment of refractory gold ore by curing with concentrated sulfuric acid

Reagent Elution Combined with Positive Pressure Filtration: A Zero-Discharge Method for Cyanide Tailings Remediation

Facile and Novel Method for the Recovery of Gold from a Calcined Concentrate Via Copper–ammonia -Thiourea System and Activated Carbon

Oxidation of Gold-Bearing Pyrite by Ammonium Persulfate

A green and efficient utilization of refractory cyanide tailings containing inclusion gold by microwave roasting

The Recovery of Gold in Low-Grade Cyanide Tailings by Chlorination Roasting

Study on Pre-oxidation of a High-Arsenic and High-Sulfur Refractory Gold Concentrate with Potassium Permanganate and Hydrogen Peroxide

Gold recovery from cyanidation residue by chloride leaching and carbon adsorption – Preliminary results from CICL process

Experimental Research on Refractory Gold Ore Pretreated by Grinding and Leaching Simultaneously with Non-cyanide

Current progress on gold recovery from refractory ore and waste electrical and electronic equipment

Sustainable and effective gold(I) separation from aurocyanides wastewater and its mechanism using guanidinium ionic liquids

Pre-oxidation of refractory gold concentrate by electrochemical methods in alkaline electrolyte

A clean and efficient innovative technology for refractory sulfide gold ore: In situ gold extraction via self-generated thiosulfate

Synergistic detoxification by combined reagents and safe filling utilization of cyanide tailings

Experimental analysis on cyanide removal of gold tailings under medium-temperature roasting

Synergistical Thiourea and Thiosulfate Leaching Gold from a Gold Concentrate Calcine with Copper-Ammonia Catalysis

Renewable ammonium chloride-induced calcium leaching of gold and copper tailings and selective preparation of vaterite CaCO 3 by CO 2 mineralization