Abstract:Accessories such as joints and terminations represent weak points in HVDC cable systems. The DC field distribution is intimately dependent on the thermal conditions of the accessory and on material properties. Moreover, there is no available method to probe charge distribution in these conditions. In this work, the field distribution in non-stationary conditions, both thermally and electrically, is computed considering crosslinked polyethylene (XLPE) as cable insulation and different insulating materials (silicone, rubber, XLPE) for a 200 kV joint assembled in a same geometry. In the conditions used, i.e., temperatures up to 70 °C, and with the material properties considered, the dielectric time constant appears of the same order or longer than the thermal one and is of several hours. This indicates that both physical phenomena need to be considered for modelling the electric field distribution. Both the radial and the tangential field distributions are analysed, and focus is given on the field distribution under the stress cone on the ground side and near the central deflector on the high voltage side of the joint. We show that the position of the maximum field varies in time in a way that is not easy to anticipate. Under the cone, the smallest tangential field is obtained with the joint insulating material having the highest electrical conductivity. This results from a shift of the field towards the cable insulation in which the geometrical features produce a weaker axial component of the field. At the level of the central deflector, it is clear that the tangential field is higher when the mismatch between the conductivity of the two insulations is larger. In addition, the field grows as a function of time under stress. This work shows the need of precise data on materials conductivity and the need of probing field distribution in 3D.

Two-dimensional Space Charge Measurement in Cable Joint Model Using the Pulsed Electroacoustic Method

An Improved Space Charge Measurement Approach for Power Cables

Feasibility of Space Charge Measurements on HVDC Cable Joints: Study Group—IEEE DEIS Technical Committee “HVDC Cable and Systems:”

DC Electric Field Optimization of AC XLPE Cable Joint in DC Operation

Radio-frequency Detection of Partial Discharge in Power Cable Joints

Automated Space Charge Classification Inside ±500-Kv HVDC Cable Insulation Using Fusion of Superpixel and Deep Features for Remote Condition Assessment.

Space Charge and Electric Field Characteristics in XLPE-Insulated Extrusion Molded Joint for HVDC Submarine Cables: Experiment and Simulation

Investigation of space charge behavior of HVDC XLPE cables using PEA method

Space Charge Accumulation between Different Insulating Materials Simulated Cable Joint for HVDC

Study on space charge accumulation characteristics of 320 kV cross-linked polyethylene cable joints

A Study on the Behavior of Interfacial Space Charge at Polymer Dielectric Double-Layer Simulating the HVDC Cable Joints

Calculation Of Space Charge And Field Distributions In A Cable Joint

Analysis of the Charge Transport in LDPE with Combined Measurement of Space Charge and Current

Comparison of on-line partial discharge detection methods for HV cable joints

Charge Transport in Full-Size HVDC Cable Joint with Modeling of XLPE/EPDM Interface

Distributed Detection and Acoustic Emission Waveform Retrieval of Cable Joint Partial Discharge

Space Charge Accumulation at Material Interfaces in HVDC Cable Insulation Part I—Experimental Study and Charge Injection Hypothesis

Effect Factors Of Pulse Injection From Outer Semi-Conducting Layer Of Cable In The Pea Technology

An Innovative Sensor for Cable Joint Monitoring and Partial Discharge Localization

Electric Field Distribution in HVDC Cable Joint in Non-Stationary Conditions