Vat photopolymerization 3D printing of thermal insulating mullite fiber-based porous ceramics

Yueqi Cao,Xiaojing Xu,Zheng Qin,Chong He,Liwen Yan,Feng Hou,Jiachen Liu,Anran Guo

DOI: https://doi.org/10.1016/j.addma.2022.103235

IF: 11

2022-12-01

Additive Manufacturing

Abstract:To satisfy the eagerness for mullite fiber-based porous ceramics (Muf-based porous ceramics) with complex geometries in high-temperature thermal insulation fields, vat photopolymerization three-dimensional (3D) printing was first employed to prepare the highly complex Muf-based porous ceramics. Herein, a photosensitive hydroxysiloxane HPMS-KH570 was employed as the resin matrix, which not only prevented the fiber agglomeration and improved the rheological properties of the slurries but also acted as a high-temperature binder to fix the fiber cross points after sintering and consequently improved the structural stability of the 3D-Muf-based porous ceramics. The effects of mullite fiber (Muf) aspect ratio and content on the performance of Muf slurries, microstructure and physical properties of the 3D-Muf-based porous ceramics were investigated. When the fiber aspect ratio was 45 and the fiber content was 6.67 vol%, the Muf slurry exhibited the most suitable properties for vat photopolymerization 3D printing, and the corresponding 3D-Muf-based porous ceramics exhibited a well-defined 3D printed lattice structure with struts consisting of randomly crisscrossing Muf. This unique 3D skeleton structure endowed the 3D-Muf-based porous ceramics with low density (0.47 g/cm3) and low room temperature thermal conductivity (0.11 W/(m·K)), enabling it a promising candidate for high-temperature (1000–1400 °C) insulation materials. Furthermore, this printing strategy provided references for vat photopolymerization 3D printing of other fiber-based materials.

engineering, manufacturing,materials science, multidisciplinary