Abstract:AISI 304L and AISI 316L are metastable austenitic stainless steels, which exhibit a good corrosion resistance due to their chromium contents but suffer from poor mechanical properties and therefore exhibit poor wear resistance. A slight hardening effect is gained by the formation of deformation-induced martensite either by cold-rolling or shot-peening. A considerable surface hardness could be achieved by plasma nitriding processes due to the formation of the so-called S-phase, the nitrogen diffusion zone. In industrial manufacturing processes cold-deformation could not be avoided and no final annealing is carried out to eliminate the deformation-induced martensite. Therefore, the knowledge about the behavior of the microstructure regarding the nitriding process and the resulting properties is fundamental. The S-phase is also assumed to improve the corrosion resistance if the plasma nitriding is performed below a critical temperature. Above this temperature chromium nitrides precipitate in the matrix and decrease the corrosion resistance.In this study, AISI 304L and AISI 316L were solution annealed and afterwards work hardened with a cold rolling degree of 38%. The surfaces were polished and shot-peened, respectively. The amount of deformation induced martensite depends on the material and this, in turn influences the nitriding behavior. It will be shown, that a highly deformed microstructure promotes the growth of the S-phase. Furthermore, the resulting surface hardness and corrosion resistances in saline solution were examined. The corrosion properties are highly dependent on the surface topography. Shot-peening increases the roughness and also induces crack like artifacts which accelerate corrosion kinetics. The results were evaluated statistically to derive correlations between the microstructure, the plasma nitriding behavior and the resulting properties.

Advances in Low-Temperature Nitriding and Carburizing of Stainless Steels and Metallic Materials: Formation and Properties

Low Temperature Nitriding of Metal Alloys for Surface Mechanical Performance

The “Expanded” Phases in the Low-Temperature Treated Stainless Steels: A Review

Low-temperature gaseous surface hardening of stainless steel: the current status

Low-Temperature Plasma Nitriding of Martensitic and Austenitic Steels to Increase Tribocorrosion Resistance*

Solutions to improve surface hardness of stainless steels without loss of corrosion resistance

The Expanded Phases Formed in Stainless Steels by Means of Low-Temperature Thermochemical Treatments: A Corrosion Perspective

V STAINLESS STEEL PROPERTY IMPROVEMENT BY ION NITRIDING AND NITROCARBURIZING

Low-Temperature Carburization of Austenitic Stainless Steels

Effect of alloying and heat treatment on the structure and tribological properties of nitrogen-bearing stainless austenitic steels under abrasive and adhesive wear

MECHANICAL AND CHEMICAL PROPERTIES OF LOW TEMPERATURE PLASMA SURFACE ALLOYED 316 AUSTENITIC STAINLESS STEEL

Effects of Initial Microstructure on the Low-Temperature Plasma Nitriding of Ferritic Stainless Steel

A Novel Method for the Development of a Low-Temperature Bainitic Microstructure in the Surface Layer of Low-Carbon Steel

Study on Low Temperature Liquid Nitrocarburizing

Study of the effect of ion nitriding regimes on the structure and hardness of steel

Short time nitriding and nitrocarburizing of martensitic stainless steel

Low-Temperature Plasma Nitriding for Austenitic Stainless Steel Layers with Various Nickel Contents Fabricated via Direct Laser Metal Deposition

From Austenitic Stainless Steel to Expanded Austenite-S Phase: Formation, Characteristics and Properties of an Elusive Metastable Phase

Nitriding behavior and corrosion properties of AISI 304L and 316L austenitic stainless steel with deformation-induced martensite

Progress in High Temperature Tribology of Metal Nitride Coatings