Abstract:Pipe cable is considered as an important form for underground transmission line. The maximum electrical current (ampacity) of power cable system mostly depends on the cable conductor temperature. Therefore, accurate calculation of temperature distribution in the power cable system is quite important to extract the cable ampacity. In the present paper, the fluid flow and heat transfer characteristics in the pipe cable with alternating current were numerically studied by using commercial code COMSOL MULTIPHYSICS based on finite element method (FEM). The cable core loss and eddy current loss in the cable were coupled for the heat transfer simulation, and the difference of heat transfer performances with pure natural convection model and radiation-convection model was compared and analysed in detail. Meanwhile, for the radiation-convection model, the effects caused by radiant emissivity of cable surface and pipe inner surface, as well as the cable location in the pipe, were also discussed. Firstly, it is revealed that the radiation and natural convection heat flux on the cable surface would be of the same order of magnitude, and the radiation heat transfer on the cable surface should not be ignored. Otherwise, the cable ampacity would be underestimated. Secondly, it is found that the overall heat transfer rate on the cable surface increases as the cable surface emissivity increases, and this is more remarkable to the upper cable. While the effect caused by the radiant emissivity on the pipe inner surface would be relatively small. Furthermore, it is demonstrated that, as cable location in the pipe falls, the natural convection heat transfer would be enhanced. These results would be meaningful for the ampacity prediction and optimum design for the pipe cable.

Research on Key Factors to Determine the Corrected Ampacity of Multicore Photoelectric Composite Cables

Real‐time Calculation of Three Core Cable Conductor Temperature Based on Thermal Circuit Model with Thermal Resistance Correction

Numerical Calculation of Real-Time Ampacity of High Voltage Power Cable Duct Laying Based on Environmental Information

Improvement of cable current carrying capacity using COMSOL software

Analysis of the Three-Dimensional Temperature Distribution and Ampacity of Forced Ventilation Multi-loop Cable Tunnel by Finite Element Method

Comprehensive Analysis of Temperature and Stress Distribution in Optical Fiber Composite Low Voltage Cable Using Finite Element Method.

Research on the Improvement of Cable Ampacity in Dense Cable Trench

Calculation of Ampacity of Double-loop XLPE Cables in Trenches Based on Multiphysics Simulation

Review of Researches on Power Cables Ampacity Calculation

An improved analytical thermal rating method for cables installed in short-conduits

Calculation of Ampacity of Underground Cables under Humidity Migration Conditions

Calculation of Ampacity Reduction Factors for Buried Cables with Surroundings Based on FEM

Improved ampacity of buried HVDC cable with high thermal conductivity LDPE/BN insulation

Experimental Research on Ampacity of Extruded Power Cable under Complex Operating Condition

Numerical Study of Convection and Radiation Heat Transfer in Pipe Cable

Multiscale Analysis of the Aging Process of Cable Insulation

Long-Term Ampacity Prediction Method for Cable Intermediate Joints Based on the Prophet Model

Analysis of Current Carrying Capacity and Temperature Field of Power Cables under Different Laying Modes

Calculation of distribution cable steady and transient temperature field in ducts

Research on loss characteristics and current-carrying capacity of low-smoke halogen-free cables

Analysis on three-core power cable temperature field and ampacity model under typical laying environment