In Situ Microstructure Modification Using a Layerwise Surface-Preheating Laser Scan of Ti-6Al-4V during Laser Powder Bed Fusion

Ahmet Alptug Tanrikulu,Behzad Farhang,Aditya Ganesh-Ram,Hamidreza Hekmatjou,Sadman Hafiz Durlov,Amirhesam Amerinatanzi

DOI: https://doi.org/10.3390/ma17081929

IF: 3.4

2024-04-23

Materials

Abstract:An innovative in situ thermal approach in the domain of LPBF for Ti-6Al-4V fabrication has been carried out with results directing towards an improved fatigue life without the need for post-processing. The thermal process involves an additional laser scan with different process parameters to preheat the selected regions of each layer of the powder bed prior to their full melting. This preheating step influences the cooling rate, which in turn affects surface characteristics and subsurface microstructure, both of which are directly correlated with fatigue properties. A thorough analysis has been conducted by comparing the preheated samples with reference samples with no preheating. Without any additional thermal processing, the preheated samples showed a significant improvement over their reference counterparts. The optimized preheated sample showed an improved prior β-grain distribution with a circular morphology and thicker α laths within the even finer prior β-grain boundaries. Also, an overall increment of the c/a ratio of the HCP α has been observed, which yielded lattice strain relaxation in the localized grain structure. Furthermore, a less-profound surface roughness was observed in the preheated sample. The obtained microstructure with all these factors delivered a 10% improvement in its fatigue life with better mechanical strength overall.

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to improve the microstructure of Ti - 6Al - 4V material by performing surface pre - heating laser scanning between layers during the laser powder bed fusion (LPBF) manufacturing process, thereby increasing its fatigue life without additional post - processing steps. Specifically, the researchers introduced an innovative in - situ heat treatment method, using different process parameters for additional laser scanning in parts of each powder bed layer to pre - heat selected areas before complete melting. This pre - heating step affects the cooling rate, which in turn affects the surface properties and subsurface microstructure, and these properties are directly related to fatigue performance.

By comparing pre - heated samples with non - pre - heated reference samples, the study found that pre - heated samples showed significant performance improvements without additional heat treatment. The optimized pre - heated samples exhibited a more uniform prior - β - grain distribution, with a circular morphology, and thicker α - lamellae within finer prior - β - grain boundaries. In addition, an overall increase in the c/a ratio of the hexagonal close - packed α - phase was observed, resulting in lattice strain relaxation in the local grain structure. The pre - heated samples also showed less pronounced surface roughness. Combining these factors, the obtained microstructure increased the fatigue life by 10% and had better overall mechanical strength.

Therefore, this study aims to improve the fatigue life and mechanical properties of Ti - 6Al - 4V material by improving the microstructure during the LPBF manufacturing process without additional post - processing steps.