Abstract:The objective of this work is to evaluate and optimize the screen‐printed front side metallization for silicon heterojunction (SHJ) solar cells. Three iterative experiments are conducted using different screen configurations and grid layout parameters. A batch of SHJ cells is metallized with an optimized front side grid layout using a knotless fine mesh screen, which results in a maximum efficiency gain of 0.17% and a decrease in silver paste laydown by ~2 mg. Within this work, we investigate the potential to optimize the screen‐printed front side metallization of silicon heterojunction (SHJ) solar cells. Three iterative experiments are conducted to evaluate the impact of the utilized fine mesh screen configurations and grid layout adaption (finger pitch) for the front side metallization on silver laydown and electrical performance of the solar cells. With respect to the screen configuration, we compare the performance of a fine‐mesh knotless screen to a conventionally angled screen demonstrating an additional gain of Δη = +0.1%abs due to reduced shading losses. Additionally, a grid layout is improved by increasing the number of contact fingers from 120 to 156. Furthermore, the current possibility to push the fine‐line printing process for low‐temperature pastes to the limit is investigated by reducing the nominal finger width wn to 20, 18, and 15 μm. It is shown that even the smallest nominal width of wn = 15 μm can be printed with high quality, leading to an additional efficiency gain of Δη = +0.15%abs as well as a reduction of silver paste laydown by −5 mg. Finally, a batch of champion cells is fabricated by applying the findings of the previous experiments, which results in a maximum efficiency of ηmax = 23.2%. Compared to the reference group without optimization, this corresponds to a gain of Δη = +0.17%abs, which comes along with an additional decrease of the silver paste laydown by approximately −2 mg. This emphasizes the significance of consistent optimization of the screen‐printing process in terms of cell performance and resource utilization for SHJ solar cells.

LIFT metallization as an alternative to screen-printing for silicon heterojunction solar cells

Towards a cutting‐edge metallization process for silicon heterojunction solar cells with very low silver laydown

Advanced metallization with low silver consumption for silicon heterojunction solar cells

Metallization optimization for high efficiency silicon heterojunction solar cells using low-temperature paste screen printing

Printed Light-Trapping Nanorelief Cu Electrodes for Full-Solution-Processed Flexible Organic Solar Cells

Review on Metallization Approaches for High-Efficiency Silicon Heterojunction Solar Cells

High‐Throughput Indirect Gravure Printing Applied to Low‐Temperature Metallization of Silicon‐Based High‐Efficiency Solar Cells

Fast screen printing and curing process for silicon heterojunction solar cells

Analysis of different printing technologies for metallization of crystalline silicon solar cells

Metal aerosol jet printing for solar cell metallization

Laser‐Sintered Silver Metallization for Silicon Heterojunction Photovoltaic Cells

Progress in screen-printed metallization of industrial solar cells with SiOx/poly-Si passivating contacts

Intense Pulsed Light Meets the Metallization of Silicon Heterojunction Solar Cells

Formation of a Copper Contact Grid on the Surface of Silicon Heterojunction Solar Cells

Evaluation of different approaches for HJT cells metallization based on low temperature copper paste

Optimized Metallization for Interdigitated Back Contact Silicon Heterojunction Solar Cells

Printing technologies for silicon solar cell metallization: A comprehensive review

Copper metallization of electrodes for silicon heterojunction solar cells: Process, reliability and challenges

A concept for Lithography-free patterning of silicon heterojunction back-contacted solar cells by laser processing