Abstract:To overcome the environmental problems during manufacturing process, the twin-fluid atomization has been demonstrated as an efficient technique to reduce the lubri-cooling fluid consumption and its pollution emission. However, the coupling between the gas, liquid, and structure of the twin-fluid nozzle directly affect the droplet characteristics and size distribution, which has a significant effect on the processing performance. In the current work, the droplet characteristics during the collaborative atomization process of a twin-fluid nozzle with two kinds of atomizing cores are investigated and compared via a phase Doppler particle analyzer (PDPA), and the droplet diameter and size distribution of a new twin-fluid nozzle (NTN) with different atomizing cores are further investigated. The results reveal that the spray atomization characteristics and droplet size distribution are obviously influenced by the performance of primary and secondary atomization, which mainly depend on the atomizing core structure and the gas to liquid mass flow rate ratio (GLR). Because the gas acceleration performance of the new atomizing core is better than that of the standard atomizing core at the same GLR, compared with the standard twin-fluid nozzle (STN), the droplet diameter decreases by approximately 33.97%, the droplet number concentration and axial velocity increase by approximately 36.39% and 34.51%, respectively, and the spray cone angle of the STN is only approximately 80% of that of the NTN. Meanwhile, the higher GLR of the twin-fluid nozzle provides more energy for the droplets, so the viscous force between the liquids is easier to overcome and the atomization characteristics are improved. Nevertheless, for a smaller GLR, the droplet size distribution is significantly affected by the structural parameters of the NTN atomizing core due to the insufficient atomization power. Moreover, a smaller throat diameter, a smaller exit diameter, and a moderate distance between the liquid channel and the atomizing core exit are beneficial for improving the droplet cumulative distribution.

Generation of Fine Particles with Specified Characteristics

Distribution and Movement of Fine Particles Injected in a Gas–solid Fluidized Bed with Hydrocarbon Liquid Spray

Scalable Droplet Generator Design Using Parallel-Arranged Capillaries with Axial Misalignment

Improving agglomeration efficiency of aerosols with sizes less than 2.5 µm by generation of vortex streams in inhomogeneous ultrasonic field

Three-Dimensional Simulation Of Effervescent Atomization Spray

Possible, impossible, and expected diameters and production rates of droplets in aerosols and sprays

Mechanism of droplet-formation in a supersonic microfluidic spray device

Effects of Atomization Injection on Nanoparticle Processing in Suspension Plasma Spray

Preparation of spray dried submicron particles: Part A - Particle generation by aerosol conditioning

Complete Breakup of Liquids into Ultrafine Droplets by Grid Turbulence

Numerical Models For Viscoelastic Liquid Atomization Spray

EFFECTS OF LIQUID PROPERTIES ON DROP MEAN DIAMETER IN EFFERVESCENT ATOMIZATION SPRAY

Effects of operating conditions on droplet deposition onto surface of atomization impinging spray

Simulation of Droplet-gas Flow in the Effervescent Atomization Spray with an Impinging Plate

Synthesis of Scalable Micro-Droplets with Heat-Driven Effect in Flow-Focusing Device.

Effects of different mesh nebulizer sources on the dispersion of powder formulations produced with a new small-particle spray dryer

Flash Boiling Atomization Triggered and Driven by Intensive Radiation

The atomizing pulsed jet

Design and Evaluation of an Aerosol Nanoparticle Generation System

Particulate atomisation design methods for the development and engineering of advanced drug delivery systems: A review

Investigation of the droplet characteristics and size distribution during the collaborative atomization process of a twin-fluid nozzle