Abstract:Emerging organic solar cells based on a ternary strategy is one of the most effective methods for improving the blend film morphology, absorption ability, and device performances. On the other hand, this strategy has had very limited success in all-polymer solar cells (all-PSCs) because of the scarcity of new polymers and the challenges faced during third component optimization. Herein, highly efficient ternary all-PSCs were developed from siloxane-functionalized side chains with a wide-band-gap (Eg) polymer, Si-BDT, which is blended with a medium and ultra-narrow Eg polymer donor and acceptor, PTB7-Th, and DCNBT-TPIC. An impressive power conversion efficiency (PCE) of 13.45% was achieved in the ternary all-PSCs [PTB7-Th(0.6):Si-BDT(0.4):DCNBT-TPIC(0.6)] with the addition of 0.4 wt equivalent Si-BDT into binary all-PSCs [PTB7-Th(1):DCNBT-TPIC(0.6) PCE of 10.11%]. In contrast, the binary all-PSCs with a Si-BDT(1):DCNBT-TPIC(0.6) active layer only exhibited a good PCE of 9.92%. More importantly, the siloxane-functionalized side chains increase the light-absorption ability, carrier mobility, blend miscibility, and film morphology in ternary devices compared to those of the binary devices. Hence, exciton dissociation, charge carrier transport, and suppressed recombination properties were facilitated. In the presence of Si-BDT, both binary and ternary all-PSCs PCEs are significantly improved. Indeed, 13.45% PCE is one of the best values reported for all-PSCs except for those based on polymerized small molecule acceptors. In addition, the ternary all-PSCs showed excellent environmental and thermal stabilities with 95 and 84% of the initial PCE retained after 900 and 500 h, respectively. These results offer effective device engineering, providing a new avenue for improving the device performance in ternary all-PSCs.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c20542.Additional text describing experimental details (materials and measurements and characterization of the all-PSCs), SCLC, UV–vis absorption spectra, UPS analysis, efficiency histograms, J–V curves, PL spectra, EDS element mapping, contact angle, GIXRD study, and recent publications based on ternary all-PSCs (PDF)This article has not yet been cited by other publications.

Boosting light harvesting of quaternary polymer solar cells through co-donor and co-acceptor with amine-functionalized graphene quantum dots and a ruthenium-based sensitizer

Dual-interface modification effect of Carbon Quantum Dots on the performance of Polymer Solar Cells

Green‐Solvent‐Processed 17% Efficient Polymer Solar Cell Achieved Synergistically by Aligning Energy Levels and Improving Morphology with the Quaternary Strategy

Study on the Influence of Embedded Structure of Carbon Quantum Dots of the Organic Solar Cells with the Territory Active Layer Structure of P3HT: PC61BM: CQDs

Improved photon-to-electron response of ternary blend organic solar cells with a low band gap polymer sensitizer and interfacial modification

Ternary All-Polymer Solar Cells with Two Synergetic Donors Enable Efficiency over 14.5%

Incorporating Graphitic Carbon Nitride (g‐c3n4) Quantum Dots into Bulk‐Heterojunction Polymer Solar Cells Leads to Efficiency Enhancement

Revisiting the Role of Graphene Quantum Dots in Ternary Organic Solar Cells: Insights into the Nanostructure Reconstruction and Effective Förster Resonance Energy Transfer

Dual Förster resonance energy transfer and morphology control to boost the power conversion efficiency of all-polymer OPVs

Facile Strategy for Third Component Optimization in Wide-Band-Gap π-Conjugated Polymer Donor-Based Efficient Ternary All-Polymer Solar Cells

Enhanced and Balanced Charge Transport Boosting Ternary Solar Cells Over 17% Efficiency

Ternary Polymer Solar Cells Enabled Using Two Donor Polymers with Broad Absorption and Cascade LUMO Levels

Enhanced Charge Transfer Between Fullerene and Non-Fullerene Acceptors Enables Highly Efficient Ternary Organic Solar Cells.

Quinacridone-based small molecule acceptor as a third component in ternary organic solar cells

Efficient Ternary Organic Solar Cells Enabled by the Integration of Nonfullerene and Fullerene Acceptors with a Broad Composition Tolerance

Rationally pairing photoactive materials for high-performance polymer solar cells with efficiency of 16.53%

Highly Efficient Ternary Solar Cells with Efficient Förster Resonance Energy Transfer for Simultaneously Enhanced Photovoltaic Parameters

Chlorinated polymer solar cells simultaneously enhanced by fullerene and non-fullerene ternary strategies

Smart Ternary Strategy in Promoting the Performance of Polymer Solar Cells Based on Bulk‐Heterojunction or Layer‐By‐Layer Structure

Using fullerene as the third component to boosting the photovoltaic performances of pyran acceptor

Ternary Strategy Enables Non‐Halogenated Solvent‐Processed All‐Polymer Solar Cells with High Efficiency Over 18%