Abstract:Silicone rubber (SIR) is widely used in the field of high-voltage cable accessories insulation due to its excellent electrical properties. However, according to statistics, in 2016 alone, there were many cable accidents at home and abroad, among which cable accessories failure accounted for 85.5%. In order to fit closely with the cable, the high-voltage cable accessories adopt the installation method of pre-expanding and maintain the expanding state in the long-term operation of the cable. The silicone rubber is deteriorated by the circumferential mechanical stress, which is easy to lead to electrical tree and finally cause breakdown fault. At present, because the steel needle electrode is easy to form gas gap with the insulating material which results in the error of electrical tree experiment under the large deformation, the research on mechanical stress is mainly focused under 30% deformation, which is far less than the actual diameter expansion ratio of 45%. In this paper, in order to approach the actual working state of the insulation material of accessories, the initial voltage and morphological characteristics of silicone rubber electrical tree under large tensile ratio of 0%, 25%, 45% and 60% were studied. In order to avoid the stress concentration at the tip of the traditional steel needle electrode, a new semi conducting needle electrode was designed and successfully manufactured, and a real-time observation system of electrical tree under power frequency was built. The results showed that the initial voltage of semi conducting needle electrode was higher than that of traditional needle electrode under the same tree initiation condition. With the increase of tensile mechanical stress, the initial voltage decreased from 15.30kV to 14.33kV, and the electrical tree tended to grow in the direction of stress application. Combined with the test results of Differential scanning calorimetry and Thermogravimetric Analysis, it can be seen that the "melting point" and the temperature of maximum thermogravimetric rate increased first and then decreased with the increase of tensile ratio. At low tensile ratio, small-scale fracture of SIR molecular chain occurred, and the amorphous region increased. At high tensile ratio, the number of broken molecular chains increased. On the whole, the physical crosslinking of silicone rubber was destroyed, some molecular segments cracked, the free volume inside the material became larger, the electrical tree was more easily induced, and the electrical tree resistance of the material decreased.

Study on the Morphology of Silicone Rubber Water Tree under AC Voltage

Electrical tree initiation and propagation in silicone rubber under long-term AC aging

Analysis of Electrical Tree Ageing in Silicone Rubber by Physicochemical Approach

Electrical Tree Growth and Its Partial Discharge Pattern in Silicone Rubber under AC Voltages

Morphology of electrical trees in silicon rubber

A Study of Water Trees in Polymers under Different Conditions

Effect of Frequency on Electrical Tree Characteristics in Silicone Rubber

Electrical Tree Initiation of Silicone Rubber after Thermal Aging

Charge Transport Dynamics and the Effects on Electrical Tree Degradation under DC Voltages in Thermally Aged Silicone Rubber

Study on Corona Aging Characteristics of Silicone Rubber Material under Different Environmental Conditions

Influence of Corona Discharge on Aging Characteristics of HTV Silicone Rubber Material

Influence of Frequency on Tree Initiation Voltage and Electrical Tree Shape in Silicone Rubber

Study on the Ageing Characteristics of Silicone Rubber for Composite Insulators under Multi-Factor Coupling Effects

Micro characterization and degradation mechanism of liquid silicone rubber used for external insulation

Micro Structural Characterization of Liquid Silicone Rubber’s Aging Phenomenon Used for External Insulation

Electrical Tree and Partial Discharge Characteristics of Silicone Rubber Under Mechanical Pressure

Effect of Silicone Grease Soaking on Electrical Tree Degradation of Silicone Rubber

Initiation and Propagation Processes of Electrical Tree in Silicone Rubber

Study on Hydrophobicity and Withstand Characteristics of Natural Aging Silicone Rubber

Effect of Large Mechanical Stress on Electrical Tree Characteristics of Silicone Rubber

Intrinsic Self-healing Characteristics of Electrical Tree in Silicone Rubber