Abstract:Purpose This paper aims to develop a model that reflects the current transformer (CT) core materials nonlinearity. The model enables simulation and analysis of the CT excitation current that includes the inductive magnetizing current and the resistive excitation current. Design/methodology/approach A nonlinear CT model is established with the magnetizing current as the solution variable. This model presents the form of a nonlinear differential equation and can be solved discretely using the Runge–Kutta method. Findings By simulating variations in the excitation current for different primary currents, loads and core materials, the results demonstrate that enhancing the permeability of the B–H curve leads to a more significant improvement in the CT ratio error at low primary currents. Originality/value The proposed model has three obvious advantages over the previous models with the secondary current as the solution variable: (1) The differential equation is simpler and easier to solve. Previous models contain the time differential terms of the secondary current and excitation flux or the integral term of the flux, making the iterative solution complicated. The proposed model only contains the time differential of the magnetizing current. (2) The accuracy of the excitation current obtained by the proposed model is higher. Previous models calculate the excitation current by subtracting the secondary current from the converted primary current. Because these two currents are much greater than the excitation current, the error of calculating the small excitation current by subtracting two large numbers is greatly enlarged. (3) The proposed model can calculate the distorted waveform of the excitation current and error for any form of time-domain primary current, while previous models can only obtain the effective value.

Modeling and Transfer Characteristics Simulation Analysis of Electronic Current Transformers

Simulation and Analysis of Electromagnetic Properties at the Secondary Port of Electronic Current Transformers Under Very Fast Transient Overvoltage

Research on Transfer Characteristics of the Electronic Transformer

Transient Performance Simulation for Current Transformers

Simulation and Test of Electromagnetic Interference with Electronic Current Transformer

Study on Output Characteristics of Electronic Current Transformer in Complex Electromagnetic Environment

Modeling and analysis for practical CT based on transient test and parameter identification

Simulation Modeling of High Impedance Transformer Based on PSCAD with Deep Correlation of Winding Structure

Experimental study and analysis on transfer characteristics of air-core current transformer

Transient Behavior of PCB Air-Core Coil Current Transformer

Study of the transient performance of Electronic Current Transformer based on printed circuit board rogowski coil

Analysis on the Transfer Characteristics of Rogowski-coil Current Transformer and Its Influence on Protective Relaying

Test study on the transient performance of the electro-magnetic type current transformer

Transfer characteristics of electronic current transducer based on integration algorithms

Experimental Research on Wide Frequency Transfer Characteristics of Voltage and Current Transformers in Substations

A Simulation Platform For The Analysis Of The Current Transformer Transient Characteristic

Design and Simulation of a New Model for Air‐gapped Current Transformers

Modeling and Simulation Analysis of Current Transformer Based on Magnetizing Current As the Solution Variable

Design and Analysis of PCB Rogowski Coil Current Transformer

A Broadband Response Model of Electronic Current Transformer Applied in Smart Grid

Study on the Conducted Coupling Effect Way Through the Electronic Transformer Under Transient Electromagnetic Interference