Abstract:Demagnetization fault in a permanent magnet synchronous motor (PMSM) degrades its performance and may cause serious catastrophes. Fault localization technique can improve the reliability and safety of PMSM and provide important information for developing operation and maintenance strategies. Thus, a fault localization method is so important. Mainstream is a common method that uses search coil installed on every stator tooth to diagnose fault location. Due to the use of a large number of search coils, the method is limited in terms of invasiveness, implementation cost, and installation. Moreover, the method can only diagnose the fault location in PMSM with one demagnetized permanent magnet (PM). This article proposes a novel method which can detect the specific location of demagnetized PMs in PMSM with any types of demagnetization faults. The method only needs three additional toroidal yoke coils wound around the stator yoke. Toroidal yoke coils are used to measure the back electromotive force (EMF). The demagnetization fault localization signals (DFLSs) are produced by basic calculation of the output signals of three search coils. The DFLSs are partitioned according to the electrical period. The location of demagnetization fault can be diagnosed through analyzing each electric period waveform of DFLSs. First, the arrangement of toroidal-yoke-type search coil and the construction method of DFLSs are introduced. Second, a partitioned analytical model of DFLSs is developed. Third, waveforms in one electric period of DFLSs under preset fault types are investigated. Finally, the method for diagnosing demagnetization fault in PMSM is proposed. The simulation and experimental results justify the precision of the proposed search coil which shows the maximum error of back EMF to be 4.1%. It also shows the ability of the method to locate demagnetized PMs when the demagnetization severity (the ratio of the change in coercive force of PM to the normal coercive force) is 10%. This study provides a new method for diagnosing demagnetization fault, as well as provides a significant reference for fault post-processing and fault-tolerant control of PMSM.

Partial Demagnetization Fault Analysis and Diagnosis for Fractional Slot Concentrated Winding PMSMs Based on DQ-axis Components

A Sinusoidal Current Control Method for SPMSM Considering Uneven Demagnetization Fault

Detection and Classification of Eccentricity and High-Resistance Connection Faults in PMSMs Using Zero-Sequence Voltage Component

An Analytical Model of Unbalanced Magnetic Force in Fractional-Slot Surface-Mounted Permanent Magnet Machines

Detecting Eccentricity Fault in Permanent Magnet Synchronous Machines by Means of Zero-Sequence Voltage Component

Influence of Healthy Winding Group Current on Three-Phase Short-Circuit and Demagnetization in Dual Three-Phase Surface-Mounted PM Machines

Solution of Permanent Magnet Synchronous Motors with Partition between Poles Halbach Magnet

MMF Harmonic Analysis of Multi-M-Phase Fractional-Slot PM Machines with Partial Operating Winding Sets

Analysis and Reduction of Detent Force in Permanent Magnet Linear Synchronous Motor

Uneven Demagnetization Fault Diagnosis in Dual Three-Phase Permanent Magnet Machines Based on Electrical Signal Difference

Demagnetization Fault Diagnosis for Magnetically Suspended PMSM Using Rotor Displacement Signals

Demagnetization Fault Detection and Location in PMSM Based on Correlation Coefficient of Branch Current Signals

Investigation of Post-Demagnetization Torque Ripple in Fractional-Slot Surface-Mounted PM Wind Power Generators after Short Circuit Faults

Investigation of Postdemagnetization Unbalanced Magnetic Force in PM Machines Considering Short-Circuit Faults

A Comparative Study on Two Outer Rotor PMSMs for In-Wheel Direct Drive under Short-Circuit Faults

No-Load Losses Based Method to Detect Demagnetisation Fault in Permanent Magnet Synchronous Motors with Parallel Branches

RLS-Based Algorithm for Detecting Partial Demagnetization under Both Stationary and Nonstationary Conditions

A Novel Method for Diagnosing Demagnetization Fault in PMSM Using Toroidal-Yoke-Type Search Coil

Influence of Dimensional Parameters on Three-Phase Short Circuit and Demagnetization in Surface-Mounted PM Machines

Design Consideration of Fractional Slot Concentrated Winding Interior Permanent Magnet Synchronous Motor for EV and HEV Applications

Modeling, Analysis, and Suppression of Demagnetization for MTPA-Driven Permanent Magnet Motors With Distributed Windings