Abstract:Ballast compaction and particle rearrangement cause ballast to rotate and move vertically and horizontally. Ballast movement, including translation and rotation, has a significant effect on track performance. Large movement of ballast particles leads to track geometry roughness, e.g., hanging ties, and thus increases potential of damage and deterioration to rails, ties and fastening components. This study investigated ballast particle movement at different locations beneath a crosstie. In the paper, a wireless device — “SmartRock” was utilized to monitor ballast movement under cyclic loading in laboratory tests. The SmartRock has a shape of a realistic ballast particle. Inside the SmartRock was imbedded a tri-axial accelerometer, tri-axial gyroscope, and tri-axial magnetometer with 9 degrees of freedom so that particle translation, rotation and orientation can be interpreted, relatively. The real-time measurements were recorded by the SmartRock and then sent to a computer via Bluetooth. In the laboratory tests, a ballast box was constructed. In the ballast box, a half section of a typical railroad track was constructed. Five hundred cyclic load repetitions were applied on the top of the rail. Translational and rotational accelerations of the particle were recorded by the “SmartRock”. Three ballast box tests were conducted. Two SmartRocks were placed beneath the middle of tie and the edge of tie, respectively but at different depths during each test — right under the tie, 12 cm beneath the tie and 25 cm beneath the tie. The results indicated that (1) ballast particles had translational as well as rotational modes under cyclic loading; (2) ballast particles had rotation together with horizontal translation; (3) particle rotation were higher beneath the edge of tie than those beneath the middle of tie; (4) Ballast movement were significantly reduced with depth. The paper also further confirmed that the SmartRock was capable of recording real-time translational and rotational accelerations, which would not have altered the motions of surrounding ballast particles due to its realistic shape of a particle, hence, provided a new means to monitor ballast particle movement in railroad engineering.

Track Substructure Performance Monitoring Using Data Collected from Smartgrid

An Automated System for Position Monitoring and Correction of Chord-Based Rail Corrugation Measuring Points

Identification of Railroad Ballast Fouling Through Statistical Process Control on Ballast Particle Movement

An Integrated Multisource and Multiscale Monitoring Technique for Assessing the Health Status of High-Speed Railway Subgrade

Wireless Monitoring of Ballastless Track Slab Deformation for High-Speed Railway

Track-monitoring from the Dynamic Response of an Operational Train

Technical Note: Three-dimensional analyses of dynamic responses of track-ground system subjected to a moving train load

Comparison of Laboratory Testing Using SmartRock and Discrete Element Modeling of Ballast Particle Movement

Ballast Fouling Identification Through Statistical Pattern Recognition Techniques on Ballast Particle Movement

Wireless sensor networks and structural health monitoring: Experiences with slab track infrastructures

Advanced Full-Scale Laboratory Dynamic Load Testing of a Ballasted High-Speed Railway Track

Identification of Sleeper Support Conditions Using Mechanical Model Supported Data-Driven Approach

Effect of Geogrid on Railroad Ballast Studied by "Smartrock"

Evaluating the Effect of Rail Fastener Failure on Dynamic Responses of Train-Ballasted Track-Subgrade Coupling System for Smart Track Condition Assessment

Study on Ballast Particle Movement at Different Locations Beneath Crosstie Using “Smartrock”

Investigations on the shearing performance of ballastless CRTS II slab based on quasi-distributed optical fiber sensing

Full-scale Model Tests on Ballasted Tracks With/without Geogrid Stabilisation under High-Speed Train Loads

Development of Structural Health Monitoring Systems for Railroad Bridge Testbeds

Geogrid Stabilization in Ballasted Trackbed for High-Speed Railways

Monitoring of Railpad Long-term Condition in Turnouts Using Extreme Value Distributions

Track Geometry Degradation Modelling Considering Multiple Indicators