Abstract:<math>{101¯2}</math> twins were introduced into the magnesium (Mg) plate AZ31 via pre-rolling along its transverse direction. The plates, both with and without the pre-induced <math>{101¯2}</math> twins, were subjected to uniaxial tension along different directions. Using crystal plasticity modeling, we found that the strengthening effect of the pre-induced <math>{101¯2}</math> twins on the macroscopic flow stress primarily arised from the increased slip resistance caused by the boundaries, rather than the orientation hardening due to the twinning reorientation (although the latter did make its contribution in some specific loading directions). Besides, the pre-existing <math>{101¯2}</math> twins were found, by both experiments and simulation, to promote the activity of prismatic 〈a〉 and pyramidal 〈c + a〉 in the parent matrix of the material. Further analysis showed that the enhanced non-basal slip activity is related to the <math>{101¯2}</math> twin boundaries' low micro Hall-Petch slope ratios of non-basal slips to basal slip. With the critical resolved shear stress (CRSS) obtained from crystal plasticity modeling and the orientation data from EBSD, a probability-based slip transfer model was proposed. The model predicts higher slip transfer probabilities and thus lower strain concentration tendencies at <math>{101¯2}</math> twin boundaries than that at grain boundaries, which agrees with the experimental observation that the strain localization was primarily associated with the latter. The present findings are helpful scientifically, in deepening our understanding of how the pre-induced <math>{101¯2}</math> twins affect the strength and slip activity of Mg alloys, and technologically, in guiding the design of the pre-strain protocol of Mg alloys.

Twinning Behaviors of Mg-Sn Alloy with Basal or Prismatic Mg2Sn

The Quantitative Study of Twinning Behavior During Compression of Mg-Sn Alloy Containing Prismatic Precipitates

Understanding the interaction of {10-12} twins and Mg17Al12 precipitates in magnesium alloys via high-resolution electron microscopy

Understanding the Interaction of {10–12} Twins and Mg17Al12 Precipitates in Magnesium Alloys Via High-Resolution Electron Microscopy

Strengthening Against {101¯2} Twinning by Discontinuous and Continuous Precipitate in a Strongly Textured Mg-9Al Alloy

Twin-twin Geometric Structure Effect on the Twinning Behavior of an Mg-4Y-3Nd-2Sm-0.5Zr Alloy Traced by Quasi-in-situ EBSD

On the interaction of precipitates and tensile twins in magnesium alloys

Twinning Characteristic in Tension of Magnesium Alloys and Its Effect on Mechanical Properties

The Precipitation Behavior of a Pretwinned Mg–6Al–1Zn Alloy and the Effect on Subsequent Deformation

Three-dimensional study of grain scale tensile twinning activity in Mg: A combination of microstructure characterization and mechanical modeling

Strengthening Against {10(1)Over-Bar2} Twinning By Discontinuous And Continuous Precipitate In A Strongly Textured Mg-9al Alloy

A Study of {10-12} Twinning Activity Associated with Stress State in Mg-3Al-1Zn Alloy during Compression

The Quantitative Regulation of Basal and Prismatic Mg2Sn to Strengthen Mg-Sn Alloys

{ 10 1 ̄ 2 } twin–twin intersection-induced lattice rotation and dynamic recrystallization in Mg–6Al–3Sn–2Zn alloy

Atomic Motion in Mg–3Al–1Zn During Twinning Deformation

On the strengthening and slip activity of Mg-3Al-1Zn alloy with pre-induced { 10 1 ̄ 2 } twins

Influence of precipitation on tension and compression twinning in Mg-6.5Zn alloy

Effect of Sm on Twinning Behavior of Mg-Gd-Y-Zr Alloy at Room Temperature Compression

Pre-strain Effect on Twinning and De-Twinning Behaviors of Mg-3Li Alloy Traced by Quasi-in-situ EBSD

Three-dimensional study of grain scale tensile twinning activity in magnesium: A combination of microstructure characterization and mechanical modeling

The Effect of Twin–twin Interaction in Mg 3al 1zn Alloy During Compression