Abstract:The irreversibility of the thermoelectric cooling (TEC) model could analyze and optimize refrigeration performance. In present work, a one-dimensional thermal conductivity model of the internal irreversible thermoelectric element was first established. Subsequently, two categories of evaluation indexes were further analyzed, i.e., cooling capacity Q c and coefficient of performance (COP). The thermodynamic model of TEC was then established jointly with finite time thermodynamics. The influences of current and the ratio of heat transfer areas between cold and hot sides on the steady-state characteristics of TEC were further discussed under Newtonian linear heat transfer. In addition, a transient thermodynamic model of TEC equipment was built to compare the effects of pulse width, pulse gradient, and pulse current on the cold side temperature of the TEC module. Theoretical results demonstrated that the effective working range of the steady-state operating current is 2A ≤ I ≤ 25A, and the area ratio of heat transfer between cold and hot sides is 0.07 ≤ x ≤ 1. The cooling capacity ( Q c ) and coefficient of performance (COP) could reach up to about 50W and 2.0, respectively. In addition, the increase of external heat transfer capacity of the hot side could reduce the transient supercooling temperature and the peak overshoot temperature, simultaneously. Afterward, the cooling capacity was remarkably enhanced. Current research could provide a reliable support for the optimization design and performance improvement of the thermoelectric cooler. Thermal conductivity model of internal irreversible thermoelectric element was established; Effects of cold and hot ends on the TEC were discussed under Newtonian linear heat transfer; Effects of pulse width, gradient and current on TEC cold end temperature were investigated; Heat transfer capacity of TEC hot end could reduce supercooling and overshoot temperatures; The irreversibility of TEC model will enhance its potentials for low grade energy exploitation.

Impacting Factors and Operation Thresholds of Electron Transpiration Cooling-Based Thermal Protection System

Investigation of the influence mechanism of hypersonic flow field environment on thermionic emission efficiency

Detailed modeling of electron emission for transpiration cooling of hypersonic vehicles

Evaluation of Computational Models for Electron Transpiration Cooling

Electron thermal internal transport barriers triggered by the effect of ion shielding

Precise temperature control of electronic devices under ultra-high thermal shock via thermoelectric transient pulse cooling

Experimental study of electron transpiration cooling with a 2-kW laser heating system

Cesium seeding for effective electron transpiration cooling in hypersonic flows

A thermal contact model encompassing near-field effects of multi-interface TEGs in hypersonic conditions

Performance Analysis of a Battery Thermal Management System Combining Thermoelectric, Composite Phase Change Material, and Liquid Cooling under Extreme Operating Conditions

A Model to Evaluate the Device-Level Performance of Thermoelectric Cooler with Thomson Effect Considered

Numerical study on transient supercooling performance of annular thermoelectric cooler

Computational fluid dynamic model of electron transpiration cooling in weakly ionized air flows

Realizing Rapid Cooling and Latent Heat Recovery in the Thermoelectric-Based Battery Thermal Management System at High Temperatures

Numerical Investigation on Radiation Effect in Transpiration Cooling

Nanoengineering-Enhanced Capillary Cooling Achieves Sustained Thermal Protection for Ultra-High Heat Flux and Temperature

Characterizing the thermoelectric cooling performance across a broad temperature range

Irreversibility of thermoelectric cooling model: Newtonian linear heat transfer and finite time thermodynamics

Designing thermoelectric self-cooling system for electronic devices: Experimental investigation and model validation

Investigation of the impact of the thermoelectric geometry on the cooling performance and thermal—mechanic characteristics in a thermoelectric cooler

Impacts of distributed thermal and electric contact resistance on performance and geometric optimization of thermoelectric generators