Abstract:A general-purpose high frame rate (HFR) medical imaging system has been developed. This system has 128 independent linear transmitters, each of which is capable of producing an arbitrary broadband (about 0.05-10 MHz) waveform of up to +/- 144 V peak voltage on a 75-ohm resistive load using a 12-bit/40-MHz digital-to-analog converter. The system also has 128 independent, broadband (about 0.25-10 MHz), and time-variable-gain receiver channels, each of which has a 12-bit/40-MHz analog-to-digital converter and up to 512 MB of memory. The system is controlled by a personal computer (PC), and radio frequency echo data of each channel are transferred to the same PC via a standard USB 2.0 port for image reconstructions. Using the HFR imaging system, we have developed a new limited-diffraction array beam imaging method with square-wave aperture voltage weightings. With this method, in principle, only one or two transmitters are required to excite a fully populated two-dimensional (2-D) array transducer to achieve an equivalent dynamic focusing in both transmission and reception to reconstruct a high-quality three-dimensional image without the need of the time delays of traditional beam focusing and steering, potentially simplifying the transmitter subsystem of an imager. To validate the method, for simplicity, 2-D imaging experiments were performed using the system. In the in vitro experiment, a custom-made, 128-element, 0.32-mm pitch, 3.5-MHz center frequency linear array transducer with about 50% fractional bandwidth was used to reconstruct images of an ATS 539 tissue-mimicking phantom at an axial distance of 130 mm with a field of view of more than 90 degrees. In the in vivo experiment of a human heart, images with a field of view of more than 90 degrees at 120-mm axial distance were obtained with a 128-element, 2.5-MHz center frequency, 0.15-mm pitch Acuson V2 phased array. To ensure that the system was operated under the limits set by the U.S. Food and Drug Administration, the mechanical index, thermal index, and acoustic output were measured. Results show that higher-quality images can be reconstructed with the square-wave aperture weighting method due to an increased penetration depth as compared to the exact weighting method developed previously, and a frame rate of 486 per second was achieved at a pulse repetition frequency of about 5348 Hz for the human heart.

Development of Spectral Radiation Imaging Diagnostic Systems for HFRC Device

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Development of radiation tolerance evaluation and measurement system for spaceborne D/A converter

Design of 50khz Thomson Scattering Diagnostic System on HFRC

High-Resolution Terahertz Hyperspectral Imaging with Swept-Frequency Dual-Comb

PFDIR - a Wideband Photonic-Assisted SAR System

A Full Digitizing Design of Measuring Systems in Diagnosing of High-Intensity Pulsed Radiation Field

Instrument-Based Noncontact Doppler Radar Vital Sign Detection System Using Heterodyne Digital Quadrature Demodulation Architecture

Design and realization of an long-wave infrared hyperspectral imaging system

An ultra-high-speed front-end intelligent digital transmission system for high-intensity pulsed radiation field diagnosis

Prototype Development of an 8mm Band 2-Dimensional Aperture Synthesis Radiometer

Use of UHF method to measure partial discharge signal under square quare-wave pulse

Design of High Voltage Pulsed Power Supply for HFRC

High Performance Data Acquisition System for IRFPA Testing

Design and Implementation of High Performance DAQ System for IRFPA Testing

Design And Implementation Of A 94ghz High Resolution Stepped Frequency Radar

The Analog Front-end Prototype Electronics Designed for LHAASO WCDA

High frame rate imaging system for limited diffraction array beam imaging with square-wave aperture weightings

Development of High Resolution TDC Implemented in Radiation Tolerant FPGAs for Aerospace Application

A Beam Phase and Energy Measurement Instrument Based on Direct RF Signal IQ Undersampling Technique

Study of a new type of hard X-ray detector for HL-2A device