Abstract:This article presents a fully integrated high-power and high-efficiency $D$ -band power amplifier (PA) with two-way differential power combining in a 28-nm bulk CMOS process. The overall performance improvement is achieved mainly from three aspects. First, the effect of resistance brought by the actual matching network on performance above 100 GHz is considered in transistor selection, and the deoverstabilization technique is proposed to select structures with high output power and high efficiency at stabilization. Meanwhile, the compensating inductors are introduced in the distributed active transformer (DAT) network to reduce RF signal leakage and insertion loss of the power combiner. Finally, considering the low intrinsic transistor gain above 100 GHz in CMOS, the effect of different interstage matching network losses on the overall efficiency is analyzed to guide the optimization objectives of different matching networks, taking into account both gain and chip area. The three-stage four-way power combining PA achieves a peak gain of 19.2 dB, a measured maximum saturated output power of 15.4 dBm, a peak power-added efficiency (PAE) of 14.25%, and a high power density of 381 mW/mm $^{2}$ . To the best of our knowledge, the proposed PA achieves the highest PAE in bulk CMOS-based D-band PAs with an output power greater than 15 dBm.

A Compact Wideband High-Efficiency Power Amplifier for Ku-Band Applications

A Compact Multilayer-Stacked Guanella Transformer Based 50–680-Mhz GaAs Power Amplifier

Design of X/Ku Dual-Wideband GaN Power Amplifier MMIC Based on Coupled Multiresonator Matching Networks

A Broadband High-Efficiency Quasi Class E Internally-matched GaN Power Amplifier with a Compact Band-Pass Output Matching Structure

Fully integrated pseudo differential K-band power amplifier in 0.13um standard CMOS

Design and Simulation of a Ku-band MMIC Power Amplifier

A W-band current combined power amplifier with 14.8dBm Psat and 9.4% maximum PAE in 65nm CMOS

A 22.8 GHz to 32.8 GHz Compact Power Amplifier with a 15 Dbm Output P1dB and 36.5% Peak PAE in 65-Nm CMOS.

Design of Ka-Band Broadband High-Gain Power Amplifier in 65-Nm CMOS

A Compact W-Band Power Amplifier with a Peak PAE of 21.1% in 65-Nm CMOS Technology

A Class-F Based Power Amplifier with Optimized Efficiency in Triple-Band

Design of A Compact 2–6 GHz High-Efficiency and High-Gain GaN Power Amplifier

An 8-18Ghz Class-Ab Power Amplifier with 16dbm Output Power and 23% PAE over Entire X-Ku Band

A Compact 0.1-19.7Ghz Ultra-Wideband Power Amplifier with ±0.5db Gain Ripple in 28 Nm CMOS Process

A Compact 144% Fractional Bandwidth CMOS Power Amplifier With an Optimization of Synthesized High-Order Matching Network.

A Ka-band Power Amplifier Improving OP1dB through Gain Expansion Achieving 28.1% PAE

A 21.6dbm CMOS Power Amplifier Using a Compact High-K Output Transformer for X-band Application

A Compact 140-GHz Power Amplifier With 15.4-dBm $P_{\mathrm{sat}}$ and 14.25% Peaking PAE in 28-nm Bulk CMOS Process

A 38-48 GHz Power Amplifier with 23-dB Gain 18.5-dBm Psat and 28% PAE in 65-nm CMOS

A Wideband Variable Gain Power Amplifier with Phase Compensation and PAE Enhancement Techniques in 65 Nm CMOS Technology

A Full Ka-Band Power Amplifier with 32.9% PAE and 15.3-Dbm Power in 65-Nm CMOS