Abstract:Fault detection of railroad signal cable is of great significance to the safety of railroad system. We propose an improved frequency-domain reflection (FDR) method based on simultaneous sampling of signal and noise for locating high-resistance faults, which is the most common fault in railroad signal cables. First, the return signal of the intact cable core and the inductive signal of the twisted pair are obtained by two-channel simultaneous sampling, and the two signals are Fourier transformed into spatial-domain waveforms. Second, the spatial-domain waveforms of the two signals have ambient noise and noise generated by multiple reflections at the transitions. We calculate the proportionality between the two spatial-domain waveforms by the least square method (LSM), denoted as the transmission factor. Finally, the fault line and its twisted pair are sampled synchronously during subsequent cable fault measurements. The fault line signal is subtracted from the product of the transmission factor and the twisted pair signal. The noise generated by the ambient noise and multiple reflections at the transfer is actively eliminated, highlighting the location of the fault and improving the localization effect of the original FDR method. A hardware system was designed based on this algorithm. The hardware system can transmit a 100-kHz–5-MHz frequency sweep signal to the cable, and the return signal required by the active noise reduction algorithm is collected by two-channel synchronized sampling and intermediate frequency (IF) sampling, and the data processing is subsequently carried out in the host computer. The improved algorithm proposed in this article achieves fault location for high impedance faults in cables below 1000 m, with a maximum resistance of 0.5 M . However, the traditional FDR methods cannot obtain effective positioning results, which verifies the effectiveness and superiority of the proposed method.

Influence of Cross Bonding Structure on Impedance Spectrum of Cable and Fault Localization Results

A Novel Method for Identifying Cable Defect and Improving Location Accuracy Based on Frequency Domain Reflectometry

Radio-frequency Detection of Partial Discharge in Power Cable Joints

Frequency-Domain Localization Method for High-Resistance Faults in Railroad Signal Cables Based on Active Noise Reduction

Transient Performance of Loss Reduction Strategy for Power Cables Installed on the Bridge

Upper Sweeping Frequency Selection for Cable Defect Location Based on STFT

Time-Domain Investigation on Cable-Induced Transient Coupling Into Metallic Enclosures

Grounding System Analysis of 220 Kv Power Cable Lines Installed Underneath a Bridge

Transient Responses Of Coaxial Cables In An Electrically Large Cabin With Slots And Windowns Illuminated By An Electromagnetic Pulse

Underground Power Cable Fault Detection and Localization Based on the Spectrum of Propagation Functions

A parameter-free fault location method for cross-bonding cable based on ranging equations

A Frequency Sweep Location Method for Soft Faults of Power Cables Based on MUSIC-Pseudospectrum

A Novel Time–Frequency-Domain Reflectometry Location Method for Power Cable Defects Based on Synchrosqueezing Transform

A Novel Non-destructive Diagnosis Method for Cable Insulation Defect Based on Broadband Impedance Spectroscopy

Analysis and Diagnosis of Shielded Cable Faults Based on Finite-Element Method and Time-Reversal Time-Frequency Domain Reflectometry

Effects of the structure and insulation material of a cable on the ability of a location method by FDR

Defect Location for Cables Based on Frequency Modulated Continuous Wave

A Novel Method for Sign Judgment of Defects based on Phase Correction in Power Cable

Cable Defect Location by Using Frequency Domain Reflectometry with Synchrosqueezing Generalized S-Transform

Multi‐type defect detection and location based on non‐destructive impedance spectrum measurement for underground power cables

A High-Resolution Defect Location Method for Medium-Voltage Cables Based on Gaussian Narrow-Band Envelope Signals and the S-Transform