Abstract:A combined steady-state and transient approach is employed to investigate the corrosion behavior of X80 pipeline steel in carbon dioxide-saturated brines. Continuous bubbling of carbon dioxide into a test vessel with 1 liter capacity is performed to simulate the flowing condition. The measurement of time-dependent open-circuit potential, polarization resistance, and electrochemical impedance spectroscopy (EIS) is conducted to interpret the evolution of dissolution processes at the corroding interface. Three distinguishing stages are observed at a temperature of 60 °C during a whole exposure of 144 h. Analyses mainly based on the consecutive mechanism show that after the first stage of the active-adsorption state, the anodic reaction is significantly retarded by the accumulation of (FeOH)ads on the iron surface, causing a sharp increase in the polarization resistance and the open-circuit potential, as well as the disappearance of the inductive loop in EIS. At the third stage, the formation of the corrosion product layer similarly reduces both the anodic and cathodic reactions, which arouses a linear increase in the polarization resistance with time and a capacitive loop in EIS but changes the open-circuit potential slightly. An increase in salinity in this study reduces the polarization resistance and enhances iron dissolution by promoting the formation and relaxation of (FeOH)ads; however, it brings little change to the developing time of the three stages obviously. At a low temperature of 20 °C, a protective product layer is not observed in carbon dioxide-saturated brine, and the dissolution of iron is mainly under activation control during the whole exposure. A notable enlarged polarization resistance and different interfacial processes are observed in an alkaline solution compared with those in acidic environments, which is deduced to be resulted from an impedance in the relaxation of (FeOH)ads by increasing pH. The observations in this study support well that the iron dissolution reaction at the initial stage exposed in carbon dioxide aqueous environments is dominant by water adsorption on the iron surface, and further investigation should be performed on the role that carbon dioxide plays in the evolution of corrosion products and the formation of a protective film on the steel surface by taking into account local water chemistry.

A Synergistic Experimental and Computational Study on CO2 2 Corrosion of X65 Carbon Steel under Dispersed Droplets Within Oil/water Mixtures

Revealing the Effect of O2, SO2 and H2O in Supercritical CO2 on the Corrosion Behavior of 316L Steel at Elevated Temperature

Molecular Origin of the CO2-Enhanced Water Wetting During Corrosion of an Oil Layer-Attached Steel Surface in Water Flows

Corrosion Behaviour of X65 Carbon Steel in Supercritical-Co2 Containing H2o and O-2 in Carbon Capture and Storage (ccs) Technology

Investigation of Supercritical CO2 Corrosion Behavior of X80 Carbon Steel in Pipelines: an in Situ Experimental and DFT Study

Corrosion Behavior of X65 Carbon Steel in Simulated Oilfield Produced Water

Electrochemical Behavior and Corrosion Mechanism of X65 Steel in CO_2-saturated Oilfield Water

Corrosion mitigation behavior of mild steel in supercritical CO<sub>2</sub> environments with varying the solution volume

Corrosion behavior of X70 steel in the supercritical CO2 mixed with SO2 and saturated water

Fluid Structure Governing the Corrosion Behavior of Mild Steel in Oil–water Mixtures

Experimental Investigation on Corrosion Behavior of X80 Pipeline Steel under Carbon Dioxide Aqueous Conditions

Cross Impact of CO2 Phase and Impurities on the Corrosion Behavior for Stainless Steel and Carbon Steel in Water-Containing Dense CO2 Environments

Effect of CO2 content on corrosion non-uniformity of 20# steel in oil–water two-phase based on wire beam electrode technique

Impact of SO2 Concentration on the Corrosion Rate of X70 Steel and Iron in Water-Saturated Supercritical CO2 Mixed with SO2

Electrochemical Investigation of the Corrosion Behavior of API 5L-X65 Carbon Steel in Carbon Dioxide Medium

Corrosion Behaviour of N80 Carbon Steel in Formation Water under Dynamic Supercritical CO 2 Condition

Multi-Physics Coupling Analysis on the Time-Dependent Localized Corrosion Behavior of Carbon Steel in CO2-H2O Environment

Experiments and Molecular Simulations to Study the Effect of Surface-Active Compounds in Mixtures of Model Oils on CO2 Corrosion during Intermittent Oil-Water Wetting

Corrosion Behavior of J55 and N80 Carbon Steels in Simulated Formation Water under Different CO2 Partial Pressures

Effect of High-Concentration O2on Corrosion Behavior of X70 Steel in Water-Containing Supercritical CO2with SO2

Electrochemical Investigation of the Corrosion of Different Microstructural Phases of X65 Pipeline Steel under Saturated Carbon Dioxide Conditions