Abstract:Laser surface texture (LST) technology can be used to increase the adherence of thermal barrier coating (TBC). The primary research method is to conduct a large number of laser experiments to determine the optimal texture parameters. To minimize costs and enhance efficiency, in the current work, five types of circular pit textures were summarized; the plane strain model was established using the transient thermomechanical coupling finite element method; the residual stress field after spraying was used as the prestress field; the influence of different textures on the distribution of the residual stress field after a thermal cycling was analyzed; and the propagation law of cracks in the coating was predicted. The current work focuses on: (1) The two-dimensional cross-sectional morphology of texture; (2) the principal stress s22 perpendicular to the interface (resulting in mode I interface crack) and the shear stress s12 parallel to the interface (resulting in mode II interface crack); (3) texture variables—diameter, depth, and spacing. The results revealed that after thermal cycling, the texture in the ceramic top coat (TC) bore tensile stress of around 350 MPa. Both sides of the pit in the metallic bond coat (BC) bore tensile stress, while the bottom bore compressive stress. Among them, the positive tensile stress of the texture with a sinusoidal section was the greatest, whereas the shear stress was the least. The maximum stress in texture increased as the diameter and depth increased, while the minimum principal stress was obtained by adjusting the spacing among the adjacent textures. The stress level in the coating was reduced by selecting the appropriate texture morphology, and the crack propagation was more complex, that is, it took a longer time before reaching failure, which is expected to improve the life.

P‐10.2: Numerical Simulation of Material Properties in Pattern Area and Evaluation of Constitutive Capture Method

An Analytical Model for Pressure Distribution in Automated Fiber Placement on Irregular Surfaces and Its Application in Aeronautical Manufacturing

Simulation of Hard-Soft Material Interaction under Impact Loading Employing the Material Point Method

Effectiveness analysis of the study on the bonding performance of car soft decoration coated interior trim based on cohesive zone model

Numerical analysis of molding process for roll imprinting based on ABAQUS

Investigation on A Direct Modeling Strategy for the Effective Elastic Moduli Prediction of Composite Material

Design and Optimization of Interface Morphology of Thermal Barrier Coatings Based on Regulation of Residual Stress: A Finite Element Simulation Study

Numerical simulations of stone-chipping resistance behaviors of automotive coatings: A CFD-DEM model and a wear prediction method

A Failure Mechanism Based Model for Numerical Modeling the Compression-after-impact of Foam-Core Sandwich Panels

Numerical Simulation and Intelligent Optimization of Wax Injection in Investment Casting

Thermo-mechanically coupled sliding contact shakedown analysis of functionally graded coating-substrate structures

Development of a Numerical Material Model for Axial Crushing Mechanical Characterization of Woven CFRP Composites

Residual Stresses in Coating-Based Systems, Part II: Optimal Designing Methodologies

Simulation of CMP Properties with Couple Stress

Method of analyzing coating structure under conical concave contact

Modeling of contact mechanics and defects investigation in automated fiber placement

Mechanical Characterization of Multifunctional Metal-Coated Polymer Lattice Structures

Numerical Analysis of Elastic Coated Solids in Line Contact

Using mixture design approach for modeling and optimizing tribology properties of PPESK composites

An Inverse Analysis-Based Optimal Selection Of Cohesive Zone Model For Metallic Materials

Full-stress Range Stiffness Characteristics and a New Constitutive Model for Tensile Behaviors of Coated Fabrics under Plane Stresses