Abstract:Nanoindentation of Ni-based single crystal alloy which has a void defect is simulated by the molecular dynamics method. Three models with different voids which have a same radius but different depth (H=1.5 nm, 3.0 nm, 4.5 nm) are contrasted to the perfect model respectively. The influence of a void and misfit dislocation on nanoindentation process are analyzed using center symmetry parameter. Nucleation and growth of dislocation on various indentation depth are researched simultaneously. After relaxation, misfit dislocations occur in all models, which indicates that the void does not affect the generation of misfit dislocation in gamma/gamma' phase. The indentation load depth curves show the shallow void (H=1.5 nm) has the greatest influence on nanoindentation. The results demonstrate that the void has two different ways to affect the nanoindentation process. Initially, the void softens the materials when the indentation depth is less than 0.375 nm. However, it will hinder the growth of dislocations because of a kind of surface force, which causes the increase of indentation load while the indentation depth is between 0.375 nm and 0.567 nm. The collapse of a void absorbs the strain energy, so the amount of stacking faults nucleation in gamma phase in model with the shallow void is less than which in the perfect model. The indentation load-depth curves show that the indentation load in the H=1.5 nm model is larger than load in the perfect model at 1.263 nm indentation depth. But when the void collapses completely, dislocations tangle around the original location of the void and more stacking faults generate comparing to the perfect model at the same indentation depth h=1.743 nm. So the indentation load declines and becomes smaller than load in perfect model. If the void locates at the interface of gamma/gamma' phase (H=3.0 nm), it influence the nanoindentation process later than H=1.5 nm model. Dissociation of misfit dislocations is observed when the indentation depth arrives the maximum value 1.748 nm in H=3.0 nm model. Stairs form on the surface of gamma phase because of the dissociation of misfit dislocations. There is almost no influence on the nanoindentation of Ni-based single crystal alloy when the void locates in the gamma' phase (H=4.5 nm).

Effect of Grain Size and Temperature on Mechanical Properties of Nanocrystalline Nickel

Grain Size and Temperature Effects on the Indentation Induced Plastic Deformations of Nano Polycrystalline Diamond

A Molecular Dynamics Study on Mechanical Performance and Deformation Mechanisms in Nanotwinned NiCo-based Alloys with Nano-Precipitates under High Temperatures

Influnence of Indenter on the Nanoindentation of Ni Based Single Crystal Alloy

Effect of Crystallographic Orientation on Nano-indentation Behavior of Nickel Based Single Crystal Super Alloys

The Influence of Grain Size and Temperature on the Mechanical Deformation of Nanocrystalline Materials: Molecular Dynamics Simulation

Orientation Effects on the Tensile Properties of Single Crystal Nickel with Nanovoid: Atomistic Simulation

Simultaneous effect of grain size and indenter dimension on the dislocation nucleation and growth in nanoindentation and nanoscratch processes

Temperature Effect on Nanotwinned Ni under Nanoindentation Using Molecular Dynamic Simulation

Unveiling the Local Deformation Behavior of Typical Microstructures of Nickel-Based Single Crystals under Nanoindentation

Influence Of Initial Indentation Point On Nanoindentation Of Ni-Based Single Crystal Line Alloys

Effects of Strain Rate, Temperature and Grain Size on the Mechanical Properties and Microstructure Evolutions of Polycrystalline Nickel Nanowires: A Molecular Dynamics Simulation

Nanoindentation Simulation of Ni-Base Single-Crystal Superalloy with the Consideration of Interface Effect

Effect of Void on Nanoindentation Process of Ni-Based Single Crystal Alloy

Effects of Microstructure and Temperature on the Mechanical Properties of Nanocrystalline CoCrFeMnNi High Entropy Alloy under Nanoscratching Using Molecular Dynamics Simulation

Effect of Temperature on Deformation and Fracture Behaviour of Nanostructured Polycrystalline Ni under Tensile Hydrostatic Stress by Molecular Dynamics Simulation

A Computational Study On The Deformation Of Nanocrystalline Nickel

Molecular dynamics study on the grain size, temperature, and stress dependence of creep behavior in nanocrystalline nickel

Grain Size Effect on the Temperature-Dependence of Elastic Modulus of Nanocrystalline NiTi

HighP-TNano-Mechanics of Polycrystalline Nickel.

Atomic Simulations of Grain Structures and Deformation Behaviors in Nanocrystalline CoCrFeNiMn High-Entropy Alloy