Abstract:Nanoindentation of Ni-based single crystal alloy which has a void defect is simulated by the molecular dynamics method. Three models with different voids which have a same radius but different depth (H=1.5 nm, 3.0 nm, 4.5 nm) are contrasted to the perfect model respectively. The influence of a void and misfit dislocation on nanoindentation process are analyzed using center symmetry parameter. Nucleation and growth of dislocation on various indentation depth are researched simultaneously. After relaxation, misfit dislocations occur in all models, which indicates that the void does not affect the generation of misfit dislocation in gamma/gamma' phase. The indentation load depth curves show the shallow void (H=1.5 nm) has the greatest influence on nanoindentation. The results demonstrate that the void has two different ways to affect the nanoindentation process. Initially, the void softens the materials when the indentation depth is less than 0.375 nm. However, it will hinder the growth of dislocations because of a kind of surface force, which causes the increase of indentation load while the indentation depth is between 0.375 nm and 0.567 nm. The collapse of a void absorbs the strain energy, so the amount of stacking faults nucleation in gamma phase in model with the shallow void is less than which in the perfect model. The indentation load-depth curves show that the indentation load in the H=1.5 nm model is larger than load in the perfect model at 1.263 nm indentation depth. But when the void collapses completely, dislocations tangle around the original location of the void and more stacking faults generate comparing to the perfect model at the same indentation depth h=1.743 nm. So the indentation load declines and becomes smaller than load in perfect model. If the void locates at the interface of gamma/gamma' phase (H=3.0 nm), it influence the nanoindentation process later than H=1.5 nm model. Dissociation of misfit dislocations is observed when the indentation depth arrives the maximum value 1.748 nm in H=3.0 nm model. Stairs form on the surface of gamma phase because of the dissociation of misfit dislocations. There is almost no influence on the nanoindentation of Ni-based single crystal alloy when the void locates in the gamma' phase (H=4.5 nm).

Influence Of Initial Indentation Point On Nanoindentation Of Ni-Based Single Crystal Line Alloys

Influnence of Indenter on the Nanoindentation of Ni Based Single Crystal Alloy

Nanoindentation Simulation of Ni-Base Single-Crystal Superalloy with the Consideration of Interface Effect

Effect of Void on Nanoindentation Process of Ni-Based Single Crystal Alloy

Atomistic Simulation of Nanoindentation on Incipient Plasticity and Dislocation Evolution in Γ/γ′ Phase with Interface and Void

Effect of Crystallographic Orientation on Nano-indentation Behavior of Nickel Based Single Crystal Super Alloys

Unveiling the Local Deformation Behavior of Typical Microstructures of Nickel-Based Single Crystals under Nanoindentation

Molecular Dynamics Simulation Analysis of the Indentation Hardness of Nano-Twinned Ni

Ni/Ni3Al interface-dominated nanoindentation deformation and pop-in events

Mechanical Properties of Micro-phases Along < 001 > Direction of Directionally Solidified Nickel-base Super-alloy by In-situ Nano-Indentation

Molecular Dynamics Analysis on the Indentation Hardness of Nano-Twinned Nickel

Molecular Dynamics Simulation of Incipient Plasticity of Nickel Substrates of Different Surface Orientations During Nanoindentation

Effects of Crystalline Anisotropy and Indenter Size on Nanoindentation by Multiscale Simulation.

Experimental and Simulation Analysis of Residual Topography Dominated Deformation Mechanism of Nanoindentation: a Case Study of Inconel 625 Superalloy

Indentation Creep Surface Morphology of Nickel-Based Single Crystal Superalloys

Atomistic simulations of the nanoindentation-induced incipient plasticity in Ni3Al crystal

Effect of indenter’s crystalline anisotropy on nanoindentation by multiscale analysis

A New Nanoindentation Approach for Determining Both Indentation Size Effect and Continuous Apparent Activation Volume During Loading of Nanocrystalline Ni and Ni-20 Wt.% Fe Alloy

Molecular Dynamics Simulation for Orientation Dependence of Deformations in Monocrystalline AlN During Nanoindentation

Indenter radius effect on mechanical response of a-(11–20), c-(0001), and m-(-1100) plane GaN single crystals in nanoindentation: A molecular dynamics study

Molecular Dynamics Study on the Edge Effect of Single Crystal Ni with Two Indenters Nanoindentation