Abstract:Disc cutter wear has emerged as a critical concern impacting the efficiency and cost budgets of TBMs (tunnel boring machines). Through statistical analysis of field data on cutter wear in a TBM tunnel, this study explores the wear rules of different types of disc cutters in granite. Grey sensitivity analysis is employed to investigate the sensitivity between the cutter ring wear rate of face cutters and two types of cutter wear influence parameters. Subsequently, reasonable parameters are selected to develop a new cutter life prediction model for face cutters. The results show that, with increases in the installation radius, the accumulated wear extent shows a linearly increasing trend for both the center and the face cutter, while it first increases and then decreases for gauge cutters, and the accumulated replacement number shows a linear growth trend for face cutters. The accumulated wear extent of the average single cutter position of gauge cutters is about 3 times that of face cutters and 7 times that of center cutters; the number of replaced cutter rings of the average single cutter position for gauge cutters is about 3–4 times that for center cutters and face cutters; and the average utilization rate of gauge cutters is the highest (80.97%). The cutter ring wear rate of face cutters is the most sensitive to three intact rock parameters (uniaxial compressive strength (UCS), Cerchar abrasion index (CAI), and equivalent quartz content (EQC)) and two TBM tunnelling parameters (cutterhead thrust (F) and cutterhead rotational speed (RPM)). Finally, a new cutter life prediction model (R2 = 0.964) for face cutters is developed based on F, UCS, and RPM. The research results can provide a certain theoretical basis for cutter wear and cutter life prediction for the face cutters of TBM projects in similar geological conditions and TBM specifications.

Identification of Cutter Flat Wear for Rock TBMs Using Vibration Signal of Shield

Development of a Real-Time Monitoring and Calculation Method for TBM Disc-Cutter's Cutting Force in Complex Ground

The energy method to predict disc cutter wear extent for hard rock TBMs

Performance Evaluation of TBM Using an Improved Load Prediction Model

Experimental Study on Partial Wear of TBM Disc Cutter

Identification of Disc Cutter Wear via Operation Parameters Combined With Vibration Data: A Case Study

Theoretical and Applied Research of the Deformation of the Continuous Cutterhead of TBM

Enhanced Wear Prediction of Tunnel Boring Machine Disc Cutters for Accurate Remaining Useful Life Estimation Using a Hybrid Model

Evaluation of TBM Cutter Wear in Granite and Developing a Cutter Life Prediction Model for Face Cutters Based on Field Data: A Case Study

Development of a Prediction Model for the Wear Evolution of Disc Cutters on Rock TBM Cutterhead

Experimental Investigation on the Influence Factors on TBM Cutter Wear Based on Composite Abrasion Test

A New Strategy for Disc Cutter Wear Status Perception Using Vibration Detection and Machine Learning

Prediction of TBM Cutter Wear in Heterogeneous Ground under High Ambient Pressure

Performance Evaluation of Hard Rock TBMs considering Operational and Rock Conditions

Prediction Model of TBM Disc Cutter Wear During Tunnelling in Heterogeneous Ground

Influence of vibration on the performance of tunnel boring machines

A field parameters-based method for real-time wear estimation of disc cutter on TBM cutterhead

Prediction Model for TBM Disc Cutter Wear in Mixed-face Ground Condition

Analysis on the Rock–Cutter Interaction Mechanism During the TBM Tunneling Process

Field Monitoring of TBM Vibration During Excavating Changing Stratum: Patterns and Ground Identification