Abstract:This article proposes an ultra-high-current 48-V-to-1-V hybrid switched-capacitor (SC) voltage regulator, named the switching bus converter, with a single-stage vertical power delivery architecture for next-generation ultra-high-power processors (e.g., graphics processing units, central processing units, application-specific integrated circuits, etc.). The proposed topology consists of two 2-to-1 SC front-ends and four 10-branch series-capacitor-buck modules, merged through four switching buses. Compared to the existing dc-bus-based architecture, the proposed switching-bus-based architecture eliminates the need for dc bus capacitors, reduces the switch count, and guarantees complete soft-charging operation. Through a topological comparison, this article reveals that the proposed topology achieves the lowest normalized switch stress and the smallest normalized passive component volume among existing 48-V-to-1-V hybrid SC demonstrations, showing great potential for both higher efficiency and higher power density than prior hybrid SC solutions. A hardware prototype was designed and built with custom four-phase coupled inductors and gate drive daughterboards to validate the functionality and performance of the proposed switching bus converter. It was tested up to 1500-A output current and achieved 92.7% peak system efficiency, 85.7% full-load system efficiency (including gate drive loss), and 759 W/in power density (by box volume), pushing the performance limit of the state-of-the-art 48-V-to-1-V solutions toward higher efficiency and higher power density.

Optimization and Design of Low-Voltage and High-Current Point-of-Load Converter under 48V Bus Architecture

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

Design of a 300 Kw Partial Power Processing Based DC-DC Converter for Electric Vehicles Extreme Fast Charging Stations

Analyses and Design of a High Power Bidirectional 48V-12V DCDC Converter System for Electric Vehicle Application.

An Integrated Design of Power Converters for Electric Vehicles.

A High Frequency High Efficiency GaN Based Bi-Directional 48V/12V Converter with PCB Coupled Inductor for Mild Hybrid Vehicle

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

Evaluation of the Front-End AC/DC Converter Circuits for Medium-Voltage-Connected Power Supply Systems

Design and Performance Evaluation of Hybrid-Switched-Capacitor Voltage Regulators for 48 V to Point-of-Load Application

An Ultrahigh Step-Down DC-DC Converter Based on Switched-Capacitor and Coupled Inductor Techniques

The Switching Bus Converter: A High-Performance 48-V-to-1-V Architecture with Increased Switched-Capacitor Conversion Ratio

A High Power Density And Efficiency Bi-Directional Dc/Dc Converter For Electric Vehicles

An 8A 998A/inch<SUP>3</SUP> 90.2% Peak Efficiency 48V-to-1V DC-DC Converter Adopting On-Chip Switch and GaN Hybrid Power Conversion

Optimized Two-Stage & Two-phase 48V-1V DC-DC Converter with Large Load Current Up to 100A

Efficiency Optimization Method and Accurate Power Loss Evaluation Method of 48 V/12 V Resonant DC–DC Converter

A High Power Buck Derived Non-Isolated Ac/Dc Led Driver

A Design of High-power Buck Converter Based on Synchronous Rectification

A 90.4% Peak Efficiency 48-to-1-V GaN/Si Hybrid Converter With Three-Level Hybrid Dickson Topology and Gradient Descent Run-Time Optimizer

Design And Optimization Of High Conversion Ratio Quasi Square Wave Buck Converters

A Monolithic High-Performance Buck Converter with Enhanced Current-Mode Control and Advanced Protection Circuits

A 1500-A/48-V-to-1-V Switching Bus Converter for Next-Generation Ultra-High-Power Processors