Abstract:Microscale electronics have become increasingly more powerful, requiring more efficient cooling systems to manage the higher thermal loads. To meet this need, current research has been focused on overcoming the inefficiencies present in typical thermal management systems due to low Reynolds numbers within microchannels and poor physical properties of the working fluids. For the first time, this research investigated the effects of a connector with helical geometry on the heat transfer coefficient at low Reynolds numbers. The introduction of a helical connector at the inlet of a microchannel has been experimentally tested and results have shown that this approach to flow augmentation has a great potential to increase the heat transfer capabilities of the working fluid, even at low Reynolds numbers. In general, a helical connector can act as a stabilizer or a mixer, based on the characteristics of the connector for the given conditions. When the helical connector acts as a mixer, secondary flows develop that increase the random motion of molecules and possible nanoparticles, leading to an enhancement in the heat transfer coefficient in the microchannel. Otherwise, the heat transfer coefficient decreases. It is widely known that introducing nanoparticles into the working fluids has the potential to increase the thermal conductivity of the base fluid, positively impacting the heat transfer coefficient; however, viscosity also tends to increase, reducing the random motion of molecules and ultimately reducing the heat transfer capabilities of the working fluid. Therefore, optimizing the effects of nanoparticles characteristics while reducing viscous effects is essential. In this study, deionized water and deionized water–diamond nanofluid at 0.1 wt% were tested in a two-microchannel system fitted with a helical connector in between. It was found that the helical connector can make a great heat transfer coefficient enhancement in low Reynolds numbers when characteristics of geometry are optimized for given conditions.

Mixing Behavior and Mass Transfer of Liquid–liquid Two-Phase Flow in an Annular Microchannel with Helical Wires

Liquid-liquid Two-Phase Flow and Mass Transfer in T-shaped Micro-Channel Network

Mixing in T-shaped Micro-Channel Network

Numerical and Experimental Investigation of Mixing Characteristics in the Constructal Tree-Shaped Microchannel

Micro-Mixing Enhancement in a Taylor-Couette Reactor Using the Inner Rotors with Various Surface Configurations

Numerical investigation of mixing performance for a helical tangential porous tube-in-tube microchannel reactor

Liquid–liquid two-phase flow in a wire-embedded concentric microchannel: Flow pattern and mass transfer performance

Characterization of the oil water two phase flow in a novel microchannel contactor equipped with helical wire static mixer

Mixing Efficiency Analysis On Droplet Formation Process In Microchannels By Numerical Methods

Mixing Performance of an Inline High-Shear Mixer with a Novel Pore-Array Liquid Distributor

A New Micromixer with Helical Microchannel and Research on Its Numerical Flow Field

Liquid–liquid flow characteristics and mass transfer enhancement in a Taylor–Couette microreactor

Liquid-liquid flow pattern and mass transfer in a rotating millimeter channel reactor

Effect of Hydrodynamic Heterogeneity on Micromixing Intensification in a Taylor–Couette Flow Reactor with Variable Configurations of Inner Cylinder

An Experimental Study of Liquid-Liquid Microflow Pattern Maps Accompanied with Mass Transfer

Performance of a helical insert in a commercial tubing as a passive micromixer to produce nanoparticles using an emulsification approach

Hydrodynamics and Mass Transfer of Liquid-Liquid Two-Phase Flow in Circular Milli-Channels: Sizing-up Effect

Mass transfer enhancement and hydrodynamic performance with wire mesh coupling solid particles in bubble column reactor

Controllable Preparation of Microscale Tubes with Multiphase Co-Laminar Flow in a Double Co-Axial Microdevice

Numerical and Experimental Investigation on a "Tai Chi"-Shaped Planar Passive Micromixer

Experimental and Theoretical Investigation on Heat Transfer Enhancement in Micro Scale Using Helical Connectors