Abstract:The hot deformation behaviors of TA15 titanium alloy were investigated by isothermal compression experiments on Gleeble-3500 thermal simulation machine. The results indicate that the flow stress curves of TA15 titanium alloy in the two-phase region are dynamic recrystallization (DRX) type while in the β single-phase region are main dynamic recovery (DRV) type. The evolution of microstructure and substructure (grain boundary misorientation and dislocation) under different process parameters were studied by using electron backscattered diffraction (EBSD) and transmission electron microscopy (TEM). Microstructure analysis shows that a large number of recrystallized α grains and martensite α′ phase appear as the strain rate decreases under the condition of two-phase region. However, lath martensite microstructure is replaced by lamellar martensite microstructure at low strain rate in β single-phase region. Grain boundary misorientation analysis indicates that low angle boundaries (LABs) transform into high angle boundaries (HABs) sufficiently by reducing strain rate or increasing deformation temperature. Texture evolution analysis shows that the degree of preferred orientation after deformation weakens and the intensity of texture decreases with strain rate increasing in the two-phase region. However, more potential slip systems are activated in the β single-phase region. TEM analysis suggests that microscopic deformation bands with high density of parallel arrangement dislocations evolve into subboundaries or boundaries. As the deformation continues, dislocations are accumulated around the subboundaries, and they promote the transformation of subgrains with LABs into new grains with HABs.

Study on the Stress Relaxation with Synchronous Ageing of Near Α Titanium Alloy

Research on stress relaxation behavior of TA15 titanium alloy

Relaxation mechanisms of near – α titanium alloy during stress relaxation with synchronous aging

Accelerated stress relaxation with simultaneously enhanced strength of titanium alloy by phase transformation and stress-induced twinning

A novel composited process of solution treatment-hot gas forming and stress relaxation aging for titanium alloys

Precipitation behavior and strengthening-toughening mechanism of hot rolled sheet of Ti65 titanium alloy during aging process

Relation Between Short-term Creep and Stress Relaxation of Titanium Alloy at High Temperature

Study on High-Temperature Flow Behavior and Substructure and Texture Evolution of TA15 Titanium Alloy

Revealing the Effect of α' Decomposition on Microstructure Evolution and Mechanical Properties in Ti80 Alloy

Experimental and Modeling Studies on the Stress Relaxation Behaviour of Ti-6Al-4V Alloy

Microstructure refinement and enhanced wear-resistance modulated by stress relaxation processing in a metastable β titanium alloy

Effects of pre-strain and stress level on stress relaxation ageing behaviour of 2195 Al-Li alloy: Experimental and constitutive modelling

Effect of Triple Annealing Treatment on Stress Relaxation of Ti-6Al-4V Alloy

Microstructural evolution and cryogenic-normal temperature deformation behavior of the near-α titanium alloy TA15 fabricated by laser powder bed fusion

Investigation on High Temperature Short-Term Creep and Stress Relaxation of Titanium Alloy

Relationship Between Microstructure and Tensile Properties on a Near-Β Titanium Alloy after Multidirectional Forging and Heat Treatment

Natural aging of a metastable β-type titanium alloy to simultaneously enhance yield strength and uniform elongation

Effect of Triple Annealing Treatment on Stress Relaxation of Ti-6A1-4V Alloy

Effect of Thermal Annealing on the Microstructure, Mechanical Properties and Residual Stress Relaxation of Pure Titanium after Deep Rolling Treatment

Effect of Aging Treatment on Superelasticity of A Ti48.8ni50.8v0.4 Alloy

Effects of Stress‐Aging Pretreatment on Hot Deformation Behavior and Microstructure Evolution of a Ni–Cr–Nb–Mo–Ti Alloy