Abstract:Non-equiatomic high entropy alloys (HEAs) and medium entropy alloys (MEAs) are expected to have the potential to exhibit good mechanical properties due to abundant composition designs compared to equiatomic alloys. It has been reported that an equiatomic CoCrNi MEA shows better strength-ductility balance than CoCrFeMnNi HEA, and there is a possibility that the mechanical properties can be further improved by changing chemical composition. Among the constituent elements, cobalt (Co) has the effect of decreasing stacking fault energy (SFE). In this study, we clarified the effect of Co-content on mechanical properties of non-equiatomic Co–Cr–Ni MEAs with different amounts of Co through investigating deformation behaviors and deformation microstructures. Cox(CrNi)(100−x) (x = 20 (Co20), 40 (Co40), 60 (Co60) at%) MEAs were processed to very high plastic strains by high-pressure torsion (HPT) and subsequently annealed under proper conditions to obtain FCC single-phase and uniform fine grain sizes. Mechanical properties of the specimens with fully recrystallized microstructures were characterized by tensile tests at room temperature. Their deformed microstructures at different tensile strain levels were observed by electron microscopy. The result of the tensile tests showed that the work-hardening rate was enhanced with increasing the Co-content although early fracture before reaching plastic instability condition occurred in Co60. Planar slip of dislocations and deformation twinning were observed in Co20 (SFE = 30 mJ/m2), while, in addition to them, deformation-induced martensitic transformation to HCP ε-martensite was observed in Co40 having lower SFE (SFE = 10 mJ/m2), leading to higher work-hardening rate. By increasing Co-content (decreasing SFE) further, phase fraction of ε-martensite greatly increased in Co60 (SFE = 0 mJ/m2) compared with Co40, and early fracture occurred due to stress concentration at intersects between martensite and grain boundaries. The present results suggested that the mechanical properties of the present materials could be effectively designed by controlling the SFE.

Effect of Fe Content on Microstructure and Mechanical Properties of Fex(Cocrni)100-X Medium-Entropy Alloys

Effect of Al Content on Microstructure and Mechanical Properties of the (Feconiv)100-Xalx High-Entropy Alloys

Effect of Cobalt-Content on Mechanical Properties of Non-Equiatomic Co–Cr–Ni Medium Entropy Alloys

Microstructural Evolution and Elevated-Temperature Strengthening Mechanism of Co-free FeCrMnNiV0.2Alx High-Entropy Alloys During Annealing

Strengthening Fe50+xMn25Cr15Ni10-x medium-entropy alloys by Ni/Fe replacement: Experiments and molecular dynamics study

Microstructural Evolution and Mechanical Properties of Al0.3CoCrFeNiSix. High-Entropy Alloys Containing Coherent Nanometer-Scaled Precipitates

Effect of Fe content on microstructures and mechanical properties of eutectic Co-Cr-Fe-Ni-Hf multi-principal element alloys

Effect of Al on Microstructure and Mechanical Properties of Cast CrCoNi Medium-Entropy Alloy

Cooling Rate and Compositional Effects on Microstructural Evolution and Mechanical Properties of (CoCrCuTi)100−xFex High-Entropy Alloys

Microstructure and tensile properties of Co-free Fe4CrNi(AlTi) high-entropy alloys

Effect of Al Addition on Microstructures and Mechanical Properties of AlxCrFeNi2.5Mo High Entropy Alloys

Effects of Al Addition on Structural Evolution and Tensile Properties of the FeCoNiCrMn High-Entropy Alloy System

Effects of Cr/Fe Ratio on Structural Evolution and Tensile Properties of the Fe75.7−xCrxNi15.1Al4.6Ti4.6 High‐Entropy Alloys

Characteristic deformation microstructure evolution and deformation mechanisms in face-centered cubic high/medium entropy alloys

Effect of Al addition on the microstructures and deformation behaviors of non-equiatomic FeMnCoCr metastable high entropy alloys

The effect of Co substitutions for Ni on microstructure, mechanical properties and corrosion resistance of Fe50Mn25Cr15Ni10 medium-entropy alloy

Microstructures and deformation mechanisms of the medium-entropy alloy (NiCoCr)76(Ni6AlTi)3

Effect of fabrication methods on microstructures, mechanical properties and strengthening mechanisms of Fe0.25CrNiAl medium-entropy alloy

Heterogeneous-structure-induced ultrahigh strength and ductility in a metastable dual-phase Fe60Cr15Ni16Al9 medium entropy alloy

Effect of Al content on microstructure and wear properties of FeCrNiMnAlx high-entropy alloys

Microstructural evolution and mechanical behavior of Co‐free (Fe40Ni30Cr20Al10)100‐x Ti x high‐entropy alloys