Abstract:In ion cancer therapy, high-intensity ion beams are used to treat tumors by taking advantage of the Bragg-Peak. Typical ion therapy centers use particle rates up to $10^{10}$ ions/second for treatment. On the other hand, such intensities are often too high when using these beamlines for particle physics experiments or as a test-beam environment in general. The project presented here aims to develop a beam position and intensity monitor, to cover a wide intensity range from a few Hz up to GHz rates, as used in clinical settings. Silicon carbide (SiC) is an attractive detector material for this application because it combines potential high radiation hardness with high thermal conductivity to avoid cooling. Moreover, its high electron saturation velocity allows very fast signals to mitigate pile-ups. However, some special properties of the material like different crystal polytypes have to be considered. In this paper, measurements on both a pad and a micro-strip SiC sensor prototype of 4H lattice geometry are shown. The sensors were tested in the laboratory using radioactive sources and with a proton beam in a wide intensity range (kHz-GHz) and with different energies (60-800 MeV) available at MedAustron, an ion cancer therapy center located in Austria. The measurements show that MIP particles cannot be detected reliably with the used discrete electronics setup in combination with the single-channel sensor. However, the strip sensor combined with an ASIC-based readout electronics from the CMS/Belle-II experiments allows to recover a certain part of the signal. This makes it possible to determine the ionization energy and average number of electron/hole pairs generated in the studied sensor samples.

High-precision CSNS Beam Monitor System Conceptual Design Based on SiC

High precision proton beam monitor system concept design on CSNS based on SiC

A ceramic GEM-based neutron beam monitor for China Spallation Neutron Source

The Proton Beam Real-time Monitor System in CSNS

A neutron beam monitor based on silicon carbide semiconductor coated with 6LiF converter

A beam monitor using silicon pixel sensors for hadron therapy

The 6Lif-Silicon Detector Array Developed for Real-Time Neutron Monitoring at White Neutron Beam at CSNS

Simulation Studies of the Beam Monitor for the CSR External-Target Experiment

An overview of design for CSNS/RCS and beam transport

Data Acquisition System for CSNS Neutron Beam Monitor

High Resolution and High Precision Beam Profile Monitor for Particle Accelerator using linear contact image sensor

SiC Based Beam Monitoring System for Particle Rates from kHz to GHz

4H-Silicon Carbide as particle detector for high-intensity ion beams

Highly Efficient GEM-based Neutron Detector for China Spallation Neutron Source

Status of the Beam Instrumentation System of CSNS

A novel silicon pixel sensor for beam monitoring applications at heavy-ion accelerators

Neutron Beam Line Design of a White Neutron Source at CSNS

Development of High Performance PIN-Silicon Detector and Its Application in Radioactive Beam Physical Experiment

The Design and Initial Testing of the Beam Phase and Energy Measurement System for DTL in the Proton Accelerator of CSNS

Design and Performance Study of a Dielectric-Filled Cavity Beam Current Monitor for HUST-PTF