Electrochemical Ammonia Production from Wastewater in a Flow Cell Reactor
Noemi Pirrone,Sara Garcia Ballesteros,Simelys Hernandez,Federico Bella
DOI: https://doi.org/10.1149/ma2023-02472322mtgabs
2023-12-22
ECS Meeting Abstracts
Abstract:Although its high carbon footprint, the Haber-Bosh (HB) process mainly dominates the NH 3 production market. Indeed, H 2 is mainly produced by fossil fuels steam reforming processes and the catalytic reaction between N 2 and H 2 requires high energy input, being carried out at high temperatures and pressures. Moreover, it should be considered that HB plants are not evenly distributed in the world, thus NH 3 and its derivates transportation to the final user is a large portion of the overall environmental impact. 1 Moreover, as the population is growing, the NH 3 demand is increasing fast to sustain the massive fertilizer utilization. For these reasons, in the last years, the research has focused on the possibility of producing ammonia from direct nitrogen electrochemical reduction (NRR) in aqueous electrolytes under ambient conditions exploiting renewable energy. This process is limited by low selectivity at high current densities and low yield, due to the high dissociation energy of the N 2 triple bond and the unavoidable hydrogen evolution reaction (HER). 2 On the other hand, NO 3 - can be easily converted into NH 3 thanks to the lower activation energy, which makes the reaction thermodynamically favoured compared to N 2 reduction. 3 Due to the massive agriculture, NO 3 - is one of the most abundant contaminants of underground waters and high levels in the human body can cause many diseases. Thus, the use of NO 3 - to produce NH 3 under ambient conditions can be carried out with lower energy consumption, but can also address the water pollution issue. 4 The aim of our work is to assess the catalytic activity of commercial MoS 2 and a synthesised Bi-based catalyst in a gas-diffusion electrode flow cell of 10 cm 2 geometrical area. Such a setup has the advantage of guaranteeing a better mass transport of the active species and of being scaled up. The electrodes are mainly made by airbrush deposition of a catalyst ink on a carbon paper support, which allows obtaining a high electrochemical active surface as a result of its high porosity. Catalyst loading and NO 3 - concentration was varied to find the optimal condition in terms of Faraday efficiency (FE) and yield. MoS 2 catalyst showed good catalytic activity towards NH 3 , with a FE between 62%-77% and yield between 2.9-13 mmol g -1 h -1 . On the other hand, synthesised Bi material showed 21% FE and 0.41 mmol h -1 g -1 , probably due to Bi final oxidation state, which is not so active towards NH 3 production. NH 3 quantification has been carried out through UV-vis colourimetric method, using both Nessler’s and Berthelot’s reagents. Even if the concentration of NH 3 is high enough to exclude that it can derive from contamination, more sensitive quantification is needed for these experiments, together with the quantification of side products, such as NO 2 - , H 2 and N 2 . References 1. M. A. Mushtaq, M. Arif, G. Yasin, M. Tabish, A. Kumar, S. Ibraheem, W. Ye, S. Ajmal, J. Zhao, P. Li, J. Liu, A. Saad, X. Fang, X. Cai, S. Ji and D. Yan, Renew. Sustain. Energy Rev. , 2023, 176 , 113197. 2. H. Iriawan, S. Z. Andersen, X. Zhang, B. M. Comer, J. Barrio, P. Chen, A. J. Medford, I. E. L. Stephens, I. Chorkendorff and Y. Shao-Horn, Nat. Rev. Methods Prim. 2021 11 , 2021, 1 , 1–26. 3. Q. Liu, Q. Liu, L. Xie, Y. Ji, T. Li, B. Zhang, N. Li, B. Tang, Y. Liu, S. Gao, Y. Luo, L. Yu, Q. Kong and X. Sun, ACS Appl. Mater. Interfaces , 2022, 14 , 17312–17318. 4. G. F. Chen, Y. Yuan, H. Jiang, S. Y. Ren, L. X. Ding, L. Ma, T. Wu, J. Lu and H. Wang, Nat. Energy 2020 58 , 2020, 5 , 605–613. This project has received funding from the European Research Council (ERC) under the European Union’s Horizon 2020 research and innovation programme (grant agreement No. 948769, project title: SuN 2 rise).