Coupling Effects of Elevated Pressure and Preheating Temperature on Sooting Tendency in Laminar Co-Flow Diffusion Flame of N-Heptane

Zijian Zhang,Yimeng Wu,Xiaozhou He,Lei Zhou
DOI: https://doi.org/10.1016/j.proci.2024.105530
IF: 6.535
2024-01-01
Proceedings of the Combustion Institute
Abstract:This study investigates the sooting tendency of n-heptane laminar co-flow diffusion flames, considering the joint impact of elevated pressure and preheating temperature. Using planar laser-induced incandescence (PLII) and line-of-sight attenuation (LOSA), soot volume fraction and yield were measured across varying pressures and preheating co-flow air temperatures. The results highlight notable changes in flame luminosity and morphology with increasing pressure and preheating temperature. Non-lifted flame height is minimally affected by pressure but slightly decreases with rising preheating temperature. Through the enhanced fuel pyrolysis and the promoted polycyclic aromatic hydrocarbon (PAH) formation, elevated pressure and preheating temperature significantly boost the overall soot loading and the soot region and expedite soot formation and oxidation. In non-lifted n-heptane flames, the maximum and planar integrated soot volume fractions exhibit a power dependence on pressure at each preheating temperature. The exponents of these dependencies linearly scale with rising preheating temperature, which is distinct from methane flames due to variations in the formation pathways to the first aromatic ring. However, at relatively high pressures and preheating temperatures, the two parameters deviate from power dependence curves. The growth rate of soot concentration diminishes with preheating temperature, suggesting pressure- and temperature-driven high soot loading suppressing the preheating effect on PAH formation. Accordingly, the logarithmic plot of the maximum soot yield is likely to plateau with pressure at a relatively high temperature. For n-heptane flames with relatively low soot loading, the maximum soot yield is more sensitive to pressure at higher preheating temperatures. From 1.0 bar to 4.0 bar, the pressure sensitivity of the maximum soot yield in (nitrogen-diluted) n-heptane flames is weaker compared to methane, n-heptane/methane, and n-octane/methane flames.
What problem does this paper attempt to address?