Abstract:This work investigates the effects of gas preheating and N2 dilution on soot formation in a series of laminar methane (CH4), ethane (C2H6), and propane (C3H8) co-flow diffusion flames. A modified Santoro-type burner was used to produce the flames with a series of preheat temperatures of both co-flow air and inlet fuels between 293 and 723 K. Planar laser-induced incandescence and line-of-sight beam extinction were employed to quantitatively measure the planar distributions of soot volume fractions, and two-color pyrometry was used to measure the soot temperature. The results show that the soot volume fraction significantly increases with the gas preheat temperature for all flames. A rise in the preheat temperature accelerates soot evolution and leads to the higher percentage of carbon conversion to soot in the flames. This enhancement is more remarkable in the flames of fuel with a lower sooting propensity than those with a high sooting propensity. Both axial and radial soot temperatures in the CH4 and C2H6 flames increase with the gas preheat temperature significantly. However, a reverse changing trend is observed in the central region of C3H8 flames, owing to the greater heat losses resulting from the incomplete combustion and strong soot radiation. Adding N2 to the fuel flow suppresses soot formation via the direct dilution effect on the fuel concentration and the indirect effect of changing the flame temperature. As the gas preheat temperature increases, an increasing proportion of the contribution of the direct dilution effect is observed in the N2-diluted C2H6 flames. In addition, the global activation energy of soot formation for the three fuels is estimated on the basis of the measured soot temperature and soot formation rate in the present work.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.0c03426?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.0c03426</a>.Calculated pyrolysis products for (a) CH4, (b) C2H6, (c) N2-diluted (50%) C2H6, (d) C3H8, and (e) N2-diluted (66.7%) C3H8 under different temperatures (Figure S1), relationship between laser fluence and normalized LII signal intensity (Figure S2), vertical laser fluence profile of the laser sheet where the laser fluence was set as approximately 0.3 J/cm2 (Figure S3), and calibrated relationship between soot volume fraction (fv) and LII signal intensity at the height from 15 to 40 mm in the propane flame IV-0, with the solid line representing the fitting curve to the experimental data and the two short dashed lines representing the boundaries of ±15% uncertainty in the fitting correction factor (Figure S4) (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.0c03426/suppl_file/ef0c03426_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Measurement of soot primary particle size in co-flow laminar diffusion flames of n-heptane at elevated pressures

Experimental and numerical investigation on soot formation characteristics in n-decane diffusion flames at elevated pressures

Experimental study on correlation between PAHs and soot in laminar co-flow diffusion flames of n-heptane at elevated pressure

Soot Concentration and Temperature Measurements in Co-flow Laminar Propane-Air Diffusion Flames at Pressures Up to 7 Bar

PAHs and Soot Formation in Laminar Partially Premixed Co-Flow Flames Fuelled by PRFs at Elevated Pressures

Assessment of Physical Soot Inception Model in Normal and Inverse Laminar Diffusion Flames

Study of soot formations in co-flow laminar diffusion flames of n-heptane and oxygenated aromatic biofuels from atmospheric condition to 2.3 bar

An experimental apparatus to measure soot morphology at high pressures using multi-angle light scattering

A numerical study of counterflow diffusion flames of methane/air at various pressures

Quantitatively OH-PLIF measurements in laminar diffusion flames of n-heptane at elevated pressures

Experimental and numerical research on the effects of pressure and CO2 dilution on soot formation in laminar co-flow methane/air diffusion flames

Experimental and numerical study of soot formation in laminar n-butylcyclohexane and n-butylbenzene diffusion flames at elevated pressures

Effect of gravity and pressure on soot formation in laminar inverse diffusion flames at elevated pressures

Flamelet LES of a Turbulent Pulverized Solid Fuel Flame Using a Detailed Phenomenological Soot Model

Investigation of soot particles morphology and size distribution produced in a n-heptane/anisole laminar diffusion flame based on TEM images

Effects of the Gas Preheat Temperature and Nitrogen Dilution on Soot Formation in Co-flow Methane, Ethane, and Propane Diffusion Flames

Soot Formation in Counterflow Ethylene Diffusion Flames from 1 to 2.5 Atmospheres

Numerical Study of Soot Formation in Laminar Coflow Diffusion Flames of Methane Doped with Primary Reference Fuels

Experimental and numerical study of the effect of elevated pressure on laminar burning velocity of lean H2/CO/O2/diluents flames

An experimental study on the particle concentration and size distribution of smoke generated by flaming N-heptane

Effect of Pressure on Burning and Soot Characteristics of RP-3 Kerosene Droplets under Sub-Atmospheric Pressure