Abstract:The critical micelle concentration (CMC) is an important parameter of widely used surfactants and needs to be measured in the application and development of surfactants. Fluorometric method is a widely used method determining CMC values owing to the advantages of highly sensitivity, fast response and wide application range. There are two common methods (I and II) of preparing samples for CMC fluorometric determination. In the process of developing CMC probes with aggregation-induced emission (AIE) characteristics, we found that methods I and II were not suitable for CMC probes with AIE charateristics and developed a new sample preparation method (III), which is not only suitable for CMC probes with AIE characteristic but also decreases operation procedures and errors owing to omitting the addition of micro amount of dyes into each sample. To ascertain if method III is also suitable for other CMC probes without AIE characteristics, the CMC values of surfactants were determined by fluorometric method using widely used pyrene without AIE charateristic as probe and methods I–III to prepare samples. The obtained experimental results proved that method III not only was suitable for preparation of samples for CMC determination of surfactants using pyrene as probe but also led to the least average deviation (methods I–III led to ±0.13, ±0.34 and ±0.05 mM deviation for the CMC determination of sodium dodecyl sulfate (SDS), respectively). The CMC determination using pyrene as probe is based on its change in the ratio ( I FIII / I FI ) of its emission peaks I and III with surfactant concentration. Unexpectedly, it was found that the I FIII / I FI value of pyrene in surfactant solutions is sensitive to the measurement conditions changing exciting light energy, such as slit widths and sample-measured number. In addition, it was found that surfactant SDS or cetrimonium bromide from different suppliers not only has significantly different CMC values but also leads to very different I FIII / I FI values of pyrene in a certain concentration of surfactant, which can be used as a simple method to distinguish the same surfactant with different CMC values.

A High-Throughput Measurement of Critical Micelle Concentrations Based on Absolute Aggregation-Caused Quenching Probes

Accurate and Sensitive Probing of Onset of Micellization Based on Absolute Aggregation‐caused Quenching Effect

Carbon Quantum Dots as Fluorescent Probes in the Measurement of the Critical Micelle Concentration of Surfactants

Detection of the critical micelle concentration of cationic and anionic surfactants based on aggregation-induced emission property of hexaphenylsilole derivatives

Detection of Trace Microcystin-Lr on a 20mhz QCM Sensor Coated with in Situ Self-Assembled MIPs

Removal of micron-scale microplastic particles from different waters with efficient tool of surface-functionalized microbubbles

Electrochemical observation of individual collision-blocking events of TX-100 nanomicelles: An accurate and universal approach for the critical micelle concentration determination of surfactants

Determination of Critical Micelle Concentration (CMC) of Surfactants Using Environmentally Sensitive Carbonized Polymer Dots

Concentration Characterization of Quaternary Ammonium Surfactants by FITC

Influence factors on the critical micelle concentration determination using pyrene as a probe and a simple method of preparing samples

Determination of Critical Micellar Aggregation Numbers of Quaternary Ammonium Gemini Surfactants Containing Modified Rosin by Steady-State Fluorescence Probe Method

Tractable Method for Rapid Quality Assessment of Therapeutic Antibodies in Harvested Cell Culture Fluid Based on FcγRIIIa-Immobilized Magnetic Microspheres.

Critical micelle concentration determination of sodium dodecyl sulfate by fluorescence spectrometry without fluorescent probe

Near‐infrared Fluorophores with Absolute Aggregation‐caused Quenching and Negligible Fluorescence Re‐illumination for in Vivo Bioimaging of Nanocarriers

High-Throughput/High-Precision Sampling of Single Cells into ICP-MS for Elucidating Cellular Nanoparticles

Quantification of quaternary ammonium compounds by liquid chromatography-mass spectrometry: Minimizing losses from the field to the laboratory

An Improved Method for Analyzing Chlormequat and Mepiquat in Source Waters by Solid-Phase Extraction and Liquid Chromatography-Mass Spectrometry

Towards more accurate bioimaging of drug nanocarriers: turning aggregation-caused quenching into a useful tool.

Flow-injection chemiluminescence method for determination of critical micelle concentration of surfactants

Quantifying the Critical Micelle Concentration of Nonionic and Ionic Surfactants by Self-Consistent Field Theory

A mix-and-click method to measure amyloid-β concentration with sub-micromolar sensitivity