An Improved Method for Analyzing Chlormequat and Mepiquat in Source Waters by Solid-Phase Extraction and Liquid Chromatography-Mass Spectrometry

Zhiyong Yu,Fen Jin,Jianying Hu,Xi Zhang,Jingfang Sun,Min Yang
DOI: https://doi.org/10.1016/j.aca.2010.08.006
IF: 6.911
2010-01-01
Analytica Chimica Acta
Abstract:A liquid chromatography–mass spectrometry (LC–MS) method for the identification and quantification of chlormequat (CQ) and mepiquat (MQ) in source waters with high sensitivity and specificity was established using WCX cartridges (150mg/6mL) for pre-concentration of the samples and using the CAPCELL PAK CR 1:4 (2.0mm×150mm 5μm, SCX:C18=1:4) column containing strong cationic exchange resins and C18 for separation. The method could solve the problem for pre-concentrating ionic compounds from water samples and avoid the MS instrument fouling problem accompanied with the use of ion-pair reagents. After the optimization of analytical conditions, quantification was achieved in the positive electrospray ionization mode using selected ion monitoring. The samples were analyzed with multi-channel mode with quantification performed at 30V cone voltage to ascertain the sensitivity and qualitative analysis performed at 60V cone voltage simultaneously. The method detection limits (MDLs) of CQ and MQ in source water were determined to be 14 and 22ngL−1. Finally, the method was used to quantify CQ and MQ in several source waters, which gave a level ranging from below the quantitation limit to 28ngL−1.
What problem does this paper attempt to address?