Abstract:The impact of plasma shaping on the properties of high density H-mode scrape-off layer (SOL) profiles and transport at the outer midplane has been investigated on TCV. The experimental dataset has been acquired by evolving the upper triangularity while keeping the other parameters constant. The scan comprises δ up values between 0.0 and 0.6, excluding negative triangularity scenarios. Within this study, a transition from type-I ELMs to the Quasi-Continuous Exhaust (QCE) regime takes place from low to high δ up . The modification of the upstream SOL profiles has been assessed, in terms of separatrix quantities, within the α t turbulence control parameter theoretical framework (Eich 2020 Nucl. Fusion 60 056016). The target parallel heat load and the upstream near-SOL density profiles have been shown to broaden significantly for increasing α t . Correspondingly, in the far SOL a density shoulder formation is observed when moving from low to high δ up . These behaviours have been correlated with an enhancement of the SOL fluctuation level, as registered by wall-mounted Langmuir probes as well as the Thermal Helium Beam diagnostic. Specifically, both the background and the filamentary-induced fluctuating parts of the first wall ion saturation current signal are larger at higher δ up , with filaments being ejected more frequently into the scrape-off layer. The midplane neutral pressure does not vary much between the two extreme δ up values, indicating that indirect effects of the change in geometry, linked to first wall recycling sources, should not play a significant role. The total core radiation increases at high δ up , on account of a stronger plasma-wall interaction and resulting larger carbon impurity intake from the first wall. This is likely associated to the enhanced first wall fluctuations, as well as a smaller outer gap and the close-to-double-null magnetic topology at high shaping.

Effects of recycling neutral on density shoulder formation in tokamak plasmas

Self‐organization of plasma edge turbulence in interaction with recycling neutrals

Plasma Shaping Effects on the Collisionless Residual Zonal Flow Level

Investigation on the density shoulder near the separatrix through monostatic reflectometry in EAST tokamak

The effect of plasma shaping on high density H-mode SOL profiles and fluctuations in TCV

Reduced Physics Model of the Tokamak Scrape-off-Layer for Pulse Design

Off-target gradient driven flows in 3D simulations of ADITYA-Upgrade tokamak scrape-off layer plasma transport

The impact of non-local parallel electron transport on plasma-impurity reaction rates in tokamak scrape-off layer plasmas

Theory-based scaling laws of near and far scrape-off layer widths in single-null L-mode discharges

An extensive analysis of SOL properties in high-δ plasmas in ASDEX Upgrade

Characterization of SOL profiles and turbulence in ICRF-heated plasmas in EAST

Modelling study of divertor W leakage for different divertor conditions with Ne seeding in EAST tokamak

Estimation of impact of non‐local ion heat flux model on transport simulation for DEMO‐relevant scrape‐off layer plasma

Numerical Studies of the Influence of Seeding Locations on D-SOL Plasmas in EAST

2D PIC Modeling of the Helical Scrape-off Layer Current Driven by Hybrid Divertor Biased Targets in Tokamak Plasmas

The effect of divertor particle sources on scrape-off-layer turbulence

Inferring the scrape-off layer heat flux width in a divertor with a low degree of axisymmetry

Effect of divertor plasma-facing materials and drift on the power decay width in the scrape-off layer and divertor on EAST

Impurity seeding for suppression of the near Scrape-Off Layer heat flux feature in tokamak limited plasmas

Understanding core heavy impurity transport in a hybrid discharge on EAST

Simulation of the impact of particle recycling on the plasma in MPS‐LD device based on the BOUT++ LPD module