Abstract:A novel non-lead, lightweight nuclear shielding material was developed by introducing W and B particles as functional components into 6061 Al alloy. The ball-milling and spark plasma sintering (SPS) were employed to fabricate the (W+B)/Al hybrid composites. Some dominant process parameters, such as ball milling time, holding time, etc, were optimized. Subsequently, the effect of W volume fraction on the microstructure and mechanical properties as well as radiation shielding performance of the composites were thoroughly investigated. It is demonstrated that the W particles are homogenously distributed throughout the Al matrix with a W volume fraction less than 20 %. Al 12 W is identified as an interfacial product at the Al-W interface. The composites containing 20 vol% tungsten particles exhibits the highest mechanical strength. When the volume fraction of W particles increases to 30 vol%, severe agglomeration of W particles occurs, and the mechanical properties are considerably deteriorated. Compared with 6061Al, the influence of T6 heat treatment on the strength of the composites is insignificant, especially for the composites with a high W content. The γ-ray shielding properties of the composites are significantly improved with increasing W content. The linear attenuation coefficient is up to 0.32 cm −1 for the composites with 30 vol% W. The thermal neutron absorption rate of the (W+B)/Al composites all achieve 99 % with a thickness of 2.2 cm. The results suggest that the developed (W+B)/Al hybrid composites exhibit extraordinary application potential as a structure-function integrated nuclear shielding materials.

Investigation of Mechanical Characteristics of Hot-Pressed Sintered Tungsten Based Advanced Shielding Materials

Microstructure and mechanical performance of W base candidate shielding materials sintered by HIP

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Investigation of a Hot-Pressed Nb–Ti–Al Alloy: Mechanical Alloying, Microstructure and Mechanical Property

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Development of Tungsten-Based Materials by Different Sintering Techniques

Microstructure and Mechanical Properties of the Powder Metallurgy Nb-16Si-24Ti-2Al-2Cr Alloy

Research on hot isostatic pressing sintering behavior of 90W-Ni-Fe-Cu alloy

Microstructure and properties of WB/Al nuclear shielding composites prepared by spark plasma sintering

Research on hot isostatic pressing sintering behavior of 90W–Ni–Fe–Cu alloy

Effect of Hot Isostatic Pressing Process Parameters on Properties and Fracture Behavior of Tungsten Alloy Powders and Sintered Bars

Recent Advances on Interface Design and Preparation of Advanced Tungsten Materials for Plasma Facing Materials

Spark plasma sintering and hot pressing of ZrB2–SiCW ultra-high temperature ceramics

Microstructural Effects of Y2O3 and TiC Additions in Tungsten

Thermal change of microstructure and mechanical properties of dispersion strengthened tungsten

Fabrication and properties of (W+B)/Al hybrid composites for nuclear radiation shielding

Isostatic Hot Pressed W–Cu Composites with Nanosized Grain Boundaries: Microstructure, Structure and Radiation Shielding Efficiency against Gamma Rays

Investigation of phase transition, tribological behavior and wear mechanisms of WC-enhanced biphase eutectic high entropy alloy by fast hot pressing sintering

Densification behavior, mechanical and electrical properties of in-situ TiB 2p /Cu composite powder via vacuum hot pressing

Mechanical Properties of a Novel Tungsten Fiber-Reinforced Tungsten Composite Prepared Through Powder Extrusion Printing and High-Pressure High-Temperature Sintering

Fabrication of Tungsten–copper Alloys by Microwave Hot Pressing Sintering