Abstract:This paper studies the feasibility of fabricating pseudo-alloys based on a W-Cu system through vacuum sintering of spherical bimetallic particles synthesized using the electric explosion of copper–tungsten wires in argon. The effects of the sintering temperature on the structure and hardness of the fabricated composites was studied. In terms of the structure of the samples, tungsten particles of predominantly spherical shapes with sizes ranging from submicrons to 80–90 μm were uniformly distributed throughout the copper matrix. Based on the analysis, the volume fractions of tungsten and copper were approximately equal. The calculated average phase compositions for all the samples were 58.9 wt% for W, 27.3 wt% for Cu, and 13.8 wt% WO2. When the annealing temperature increased from 1100 °C to 1250 °C, the wetting of tungsten by molten copper improved, which resulted in the porosity of the copper matrix being at the minimum, as observed in the contact zone. Due to good wetting and a decrease in the viscosity of copper, rearrangement of the solid phase of the tungsten in the bulk of the composites improved, and the density and hardness of the pseudo-alloy increased. The formation of coarse tungsten grains is caused by the fact that submicron and micron particles are growing in size and merging into agglomerates during the course of liquid-phase sintering, and this happens because of the high surface activity of ultrafine particles. Further research will be devoted to solving the discovered problems.

Fabrication of Tungsten–copper Alloys by Microwave Hot Pressing Sintering

Long-term Ball Milling and Hot Pressing of In-Situ Nanoscale Tungsten Carbides Reinforced Copper Composite and Its Characterization

Microstructure and Properties of In-Situ TiC Reinforced Copper Nanocomposites Fabricated Via Long-Term Ball Milling and Hot Pressing

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Influences of temperatures on tungsten copper alloy prepared by microwave sintering

Development of Tungsten-Based Materials by Different Sintering Techniques

Electroless Copper Plating of Tungsten Powders and Preparation of WCu20 Composites by Microwave Sintering

Microstructure and Properties of W Cu Composites with Low Copper Content at Different Sintering Temperatures

Effect of the microstructure and properties of graphite/copper composites fabricated by microwave sintering

Sintering Densification of Cu/Al2O3p Nano-Composite Powders by Electroless Copper Plating

Study of Hot-press Sintering Process of Nanometer Cu-Al_2O_3 Composite

Fabrication of Diamond-WC-Based Cemented Carbide Composites by Microwave Sintering

Effect of sintering temperature on microstructure and properties of nano-WC particle reinforced copper matrix composites prepared by hot-pressing sintering

Microstructure and high-temperature mechanical properties of Cu-W composite prepared by hot isostatic pressing

Pressure Effects on a Novel W-Mo-Cu Alloy by Large Current Electric Field Sintering: Sintering Behavior, Microstructure and Properties

Effects of Sintering Temperature on the Microstructure and Properties of a W-Cu Pseudo-Alloy

Effect of Microwave-Activated Sintering on Microstructure and Properties of Graphite/Copper Composites

Effect of Hot-Pressing Pressure on the Microstructure and Thermal Conductivity of Copper/Ti-Coated Diamond Composites

Research on hot isostatic pressing sintering behavior of 90W-Ni-Fe-Cu alloy

Tungsten heavy alloy: Nano-crystallinity and alloying induced low temperature sintering, microstructure and mechanical properties

Fabrication of SiC reinforced aluminium metal matrix composites through microwave sintering