Abstract:Current semiconductor gas sensors still have significant limitations in achieving rapid measurement of hydrogen at lower operating temperatures. Therefore, in this article, ZnO–In2O3 sensors modified with noble metal Ag are designed by constructing a heterojunction and combining it with noble metal modification for the rapid detection of hydrogen at low (working) temperatures. In this article, hydrogen gas sensors based on ZnO multilayer nanosheets and In2O3 nanoparticle (NP) composites were first synthesized through a one-step hydrothermal route. Then, on top of this, the loading of Ag NPs was successfully achieved by the chemical reduction method, and finally, the hydrogen gas sensors based on ZnO–In2O3 ternary nanocomposite modified with Ag NPs were prepared. The physicochemical features of the gas-sensitive substances were described by various characterization techniques. The sensing performance of ZnO, ZnO–In2O3, and Ag-modified ZnO–In2O3 sensors was systematically tested. The test results manifest that the Ag NPs-loaded ZnO–In2O3 sensor responds up to 103.75 to 100-ppm H2 at an inferior temperature of 160 °C with the response/recovery times of 1.6 and 47.8 s, respectively, and the lowest detectable gas concentration of 2 ppm. In addition, the gas-sensitive element exhibits favorable repeatability, stability, and excellent selectivity. Based on the experimental test results and characterization data resolution, the improved inductive capability of the sensors is chiefly attributed to the expansion of the specific surface area of the gas-sensitive material (39.8412 m2/g), the constitution of the heterojunction interface, and the cooperation of chemical and electronic sensitization of noble metal Ag.

Ag-modified Co3O4-In2O3 Nanohollow Microspheres for H2 Detection

Ag Nanoparticle-Modified ZnO–In2O3 Nanocomposites for Low-Temperature Rapid Detection Hydrogen Gas Sensors

Low detection based on Pd Pt /In2O3 nanospheres for rapid hydrogen detection

Highly Selective Detection of Trace Hydrogen Against CO and CH4 by Ag/Ag2O–SnO2 Composite Microstructures

ZnO@CuO Hollow Nanosphere-Based Composites Used for the Sensitive Detection of Hydrogen Sulfide with Long-Term Stability

Ag modified Tb-doped double-phase In2O3 for ultrasensitive hydrogen gas sensor

CeO2 nanorods decorated In2O3 nanoparticles for enhanced low temperature detection of hydrogen

ZnO@CuO hollow nanospheres based composites used for sensitive detection of hydrogen sulfide with long-term stability

Metal Organic Framework-Derived Porous Ni-doped In2O3 for Highly Sensitive and Selective Detection to Hydrogen at Low Temperature

PdAg Alloy Modified SnO2 Nanoparticles for Ultrafast Detection of Hydrogen

Room-temperature Hydrogen Sensor Based on Grain-Boundary Controlled Pt Decorated In2O3 Nanocubes

Preparation of a high-performance H2S gas sensor based on CuO/Co3O4 composite derived from bimetallic MOF

MEMS sensor based on MOF-derived WO3-C/In2O3 heterostructures for hydrogen detection

Metal organic framework-derived porous Ni-doped In 2 O 3 for highly sensitive and selective detection to hydrogen at low temperature

High selectivity and response H2 sensors based on ZnO@ZIF-71@Ag nanorod arrays

Synthesis and Characterization of Highly Sensitive Hydrogen (H₂) Sensing Device Based on Ag Doped SnO₂ Nanospheres.

Ultrahigh-response Hydrogen Sensor Based on PdO/NiO Co-Doped In2O3 Nanotubes

Preparation of 2-Butanone Gas Sensor Based on Ag-Decorated In2O3 Nanocube with High Response and Low Detection Level

Bimetal Pd/Ni functionalized WO<sub>3</sub> nanospheres for sensitive low-concentration hydrogen detection

NiO-CuO Hydrangeas-Like Composite Derived from Ni/Cu Bimetallic MOFs for Sensitive Detection of H2S at Room Temperature

Sensitivity and Selectivity Pt Loaded SnO2–Co3O4 Gas Sensor for Hydrogen Detection