Abstract:Inverter-fed traction motors used in motor train unit are regarded as the research object for insulation electric aging mechanism,based on research productions of insulation technique of inverter-fed motors.High frequency equivalent circuit models of cable and stator winding are established to simulate over-voltage of motor terminals and uneven voltage distribution of windings.A novel high frequency high voltage test system has been developed to carry out life time tests of traction motor windings.Change tendency of dielectric loss,partial discharge and thermally stimulated current(TSC) are used to deduce insulation electric breakage mechanism.High frequency equivalent circuit models of cable and stator winding are established to simulate over-voltage of motor terminals and uneven voltage distribution of windings.The simulation results show that the over-voltage is the function of rise time,cable length and reflection ratio on motor terminals.Critical length and critical rise time is corresponding one to one.The over-voltage is up to the maximum value as long as the cable length is greater than the critical length.A novel high frequency high voltage test system has been developed in place of inverters to carry out insulation aging test.Pulse square waves are generated by IGBT and are enlarged by high frequency and high voltage transformers in the device.The maximum value of high frequency and high voltage square waves is up to 10 kV.The results of life tests of motor windings indicate that the relationship of insulation lifetime and the amplitude of pulses is the inverse power law model,the relationship of insulation lifetime and the frequency of pulses is exponential model under continuous pulses condition.When the test ambient temperature is below 200 ℃,the temperature has little influence on insulation lifetime of magnet wire with polyimide corona resistant film insulation.A novel partial discharge detection device was developed by impulse current sensor,oscillograph and computer.According to the characteristics of the tested signals,a new algorithm based on wavelet-envelope detection technique is proposed to filter EMI from the test system and space electromagnetic waves.Because of the influence of very large dV/dt and high frequency plus-minus voltage conversion,partial discharges under continuous square waves condition are different from those under sine voltage condition.On the one hand,larger dV/dt leads to higher breakdown voltage.On the other hand,high frequency plus-minus voltage conversion causes a lot of space charge cumulated on the insulation surface.Large breakdown voltage and space charge cumulation result in discharge pulses with short rise time and large magnitude.The number,magnitude and power of partial discharges increase with the temperature,frequency and voltage change of square waves.The number of partial discharge become large with the frequency of square wave increase in the unit time,but it becomes small in one period of square wave.Contrast tests are carried out under AC and 10 kHz square wave pulse conditions. The differences between AC aging and square wave pulse aging are studied based on change curves of dielectric loss,partial discharge pattern and TSC.These curves prove that square wave pulses bring more defects than AC voltage to the insulation materials.Under square wave pulse condition,the two key factors which lead to insulation aging are partial discharge and space charge.Damage actions of partial discharges and space charges are intensified with voltage,frequency and temperature increasing.Due to the enormous destruction of partial discharges under the square wave condition,the weaknesses of insulation structure will break down rapidly if partial discharges occur.Discharge channel comes into being as a result of the cooperation of partial discharges and space charges.Insulation surfaces are destroyed by partial discharges.Injection and draw-off of electric charges generating by partial discharges result in molecular chain fracture inside insulation structure.Subsequently,discharge channels are expanded along the breaking point in the insulation.Finally,the process leads to insulation breakdown.

Insulation Lifetime Evaluation of Electrical Machines under Electrical Aging and Thermal Overload Transient

Insulation for Rotating Low-Voltage Electrical Machines: Degradation, Lifetime Modeling, and Accelerated Aging Tests

Time-to-Failure Analysis of Short-Duty Cycle, Inverter-Fed Electrical Machines Exposed to Prevailing Electrical Stress

Insulation Capacitance As Diagnostic Marker for Thermally Aged, Low Voltage Electrical Machines

Lifetime Model for Inverter-fed Electrical Machines Windings Including Thermal Aging and Partial Discharge Risk

Research on Deterioration Mechanism of Oil-paper Insulation of 220 Kv Current Transformer

Investigation on Thermal Aging and Degradation of XLPE for High Voltage Cable Applications

Reliability-Oriented Multi-Objective Optimization of Electrical Machines Considering Insulation Thermal Lifetime Prediction

Insulation Life-Span Models for Electrical and Thermal Aging under Continuous High Square Impulses Voltage

Reliability-Oriented Multiobjective Optimization of Electrical Machines Considering Insulation Thermal Lifetime Prediction

Investigation on Insulation Electrical Aging Mechanism of Inverter-Fed AC Traction Motors

Impact of Vibrations Exposure Cycles on Wire Insulation Lifetime During Thermal Qualification

Research on Electrical Aging Lifetime Model of Insulation Material under High Voltage Square Impulses for Inverter-Fed Motors

Life Models Of Polyimide Film Under Combined Thermal And Electrical Stresses Used In Inverter-Fed Traction Motor

Determination of Electrical Aging Test Voltage Level under a Low-Pressure Environment for Accurate Lifetime Prediction

Combined Electrical and Thermal Aging of Alumina Filled Epoxy Solid Insulators for GIS

Investigation on Humidity Effect on Partial Discharge Considering Thermal Aging

Investigation On Aging Mechanism Of Winding Insulation Used In Inverter-Fed Traction Motors

Research Development of Aging Models of Insulation Materials Based on Space Charge Effect

Investigating Aging Characteristics of Oil-Immersed Power Transformers' Insulation in Electrical–Thermal–Mechanical Combined Conditions

Aging Characteristics Analysis of Inter-turn Insulation Using Dielectric Loss