Abstract:This article proposes a fault-tolerant control method for an input-parallel–output-series (IPOS) converter under open-circuit switch failure, which mainly focuses on two parts: fault diagnosis (fault detection and fault identification) and remedial action. The fault diagnosis is realized based on immersion and invariant observer (I&IO), which has strong robustness to parameter uncertainty and external disturbances, and therefore, it can be designed using only the crude converter model with nominal parameters. Moreover, the sampling frequency required by the fault diagnosis is the same as the frequency required by the system controller. Thus, the fault diagnosis module can be easily embedded in the well-designed power system without extra sensors. Based on the method, the open-circuit fault in power switches can be detected and identified within two switching periods. As for remedial action, two redundant switches are needed for postfault reconfiguration. Also, the remedial action can be immediately triggered after the switch failure is detected. To reduce the complexity of remedial action, the same postfault reconfiguration will be carried out for the open-circuit failure in different switches. Besides, system controllers are also carefully designed to guarantee the performance of the postfault converter. Both simulations and experiments are conducted for the validations, and the results have shown the effectiveness, robustness, and rapidity of the proposed method.

A Sensorless Open Circuit Fault Identification Method for Interleaved Boost Converter

A Robust Open-Circuit Fault Diagnosis Method for Three-Phase Interleaved Boost Converter

A Fault-Tolerant Control Method for Interleaved Boost Converters

Reconstructed Phase Current-Based Fault Diagnosis Method for Interleaved Buck Converter

Fault diagnosis scheme for open-circuit faults in switched reluctance motor drives using fast Fourier transform algorithm with bus current detection

Robust Open-Circuit Fault Diagnosis of Multi-Phase Floating Interleaved DC–DC Boost Converter Based on Sliding Mode Observer

Open-Circuit Switch Fault Diagnosis and Fault- Tolerant Control for Output-Series Interleaved Boost DC–DC Converter

A Sensorless Current Balance Control Method for Interleaved Boost Converters Based on Output Voltage Ripple

L- and LCL-Filtered Grid-Tied Single-Phase Inverter Transistor Open-Circuit Fault Diagnosis Based on Post-Fault Reconfiguration Algorithms

An Observer-Based Switch Open-Circuit Fault Diagnosis of DC-DC Converter for Fuel Cell Application

IGBT Open-Circuit Fault Diagnosis for Modular Multilevel Converter With Reduced-Number of Voltage Sensor Measuring Technique

Stator inter-turn fault detection for the converter-fed induction motor based on the adjacent-current phase-shift

Cascaded SAPF Fault Diagnosis Method Based on H-bridge Voltage and Current

Wavelet Packet Decomposition-Based Fault Diagnosis Scheme for Srm Drives with A Single Current Sensor

A Fast Diagnosis Method for Both IGBT Faults and Current Sensor Faults in Grid-Tied Three-Phase Inverters With Two Current Sensors

An Open-Circuit Fault Diagnosis Method for LLC Converters

An Improved Switching Method-Based Diagnostic Strategy for IGBT Open-Circuit Faults in Hybrid Modular Multilevel Converters

Real-time Diagnosis of Open Circuit Faults in Three-Phase Voltage Source Inverters

A Coupled Inductor Scheme for CLLC Bidirectional Converter and Optimized Current Detection Method

Multiple Open-Circuit Fault Detection and Isolation Using Universal Low-Cost Diagnosis Circuits for Reconfigurable Dual-Active-Bridge Converters

A Novel Open-Circuit Fault Diagnosis Method for Voltage Source Inverters With a Single Current Sensor