Abstract:This article proposes a fault-tolerant control method for an input-parallel–output-series (IPOS) converter under open-circuit switch failure, which mainly focuses on two parts: fault diagnosis (fault detection and fault identification) and remedial action. The fault diagnosis is realized based on immersion and invariant observer (I&IO), which has strong robustness to parameter uncertainty and external disturbances, and therefore, it can be designed using only the crude converter model with nominal parameters. Moreover, the sampling frequency required by the fault diagnosis is the same as the frequency required by the system controller. Thus, the fault diagnosis module can be easily embedded in the well-designed power system without extra sensors. Based on the method, the open-circuit fault in power switches can be detected and identified within two switching periods. As for remedial action, two redundant switches are needed for postfault reconfiguration. Also, the remedial action can be immediately triggered after the switch failure is detected. To reduce the complexity of remedial action, the same postfault reconfiguration will be carried out for the open-circuit failure in different switches. Besides, system controllers are also carefully designed to guarantee the performance of the postfault converter. Both simulations and experiments are conducted for the validations, and the results have shown the effectiveness, robustness, and rapidity of the proposed method.

An Open-Circuit Fault Diagnosis Method for LLC Converters

Switch Open-Circuit Fault Diagnosis Method Using Bridge Arm Midpoint Voltage Integral for LLC Resonant Converter

Fault diagnosis scheme for open-circuit faults in switched reluctance motor drives using fast Fourier transform algorithm with bus current detection

A Simple and Effective Open-Circuit-Fault Diagnosis Method for Grid-Tied Power Converters—A New Technique Based on Tellegen's Theorem

A Fault Diagnosis Method for Solid-state Fault Current Limiters Used in Three Phase Ungrounded System

Fast Transistor Open-Circuit Faults Diagnosis in Grid-Tied Three-Phase VSIs Based on Average Bridge Arm Pole-to-Pole Voltages and Error-Adaptive Thresholds

L- and LCL-Filtered Grid-Tied Single-Phase Inverter Transistor Open-Circuit Fault Diagnosis Based on Post-Fault Reconfiguration Algorithms

Open-Circuit Switch Fault Diagnosis and Fault- Tolerant Control for Output-Series Interleaved Boost DC–DC Converter

Fast Diagnosis of Multiple Open-Circuit Faults in a T-type Inverter Based on Voltages Across Half-Bridge Switches

A Unified Open-Circuit-Fault Diagnosis Method for Three-Level Neutral-Point-Clamped Power Converters

A Fault-Tolerant LLC Converter With High Reliability and Low Cost for Two-Stage Converters

Wavelet Packet Decomposition-Based Fault Diagnosis Scheme for Srm Drives with A Single Current Sensor

Fault Diagnosis of Power Converter for Switched Reluctance Motor Based on Discrete Degree Analysis of Wavelet Packet Energy

Cascaded SAPF Fault Diagnosis Method Based on H-bridge Voltage and Current

An Observer-Based Switch Open-Circuit Fault Diagnosis of DC-DC Converter for Fuel Cell Application

A Robust Open-Circuit Fault Diagnosis Method for Three-Phase Interleaved Boost Converter

Fast Diagnostic Method of Open Circuit Fault for Modular Multilevel DC/DC Converter Applied in Energy Storage System

An Intelligent Fault Diagnosis Method Based on Extension Theory for DC–AC Converters

Switching Function Model-Based Fast-Diagnostic Method Of Open-Switch Faults In Inverters Without Sensors

An Open-Switch Fault Diagnosis Method for Three-Phase Voltage Source Converter Using Tracking Differentiator

Incipient Fault Diagnosis Method for DC–DC Converters Based on Sensitive Fault Features