Abstract:In this study, a comprehensive system-level model was developed for a proton exchange membrane fuel cell (PEMFC) system with a dead-ended anode (DEA) mode. The global system model consisted of a series of local component models, including PEMFC stack, manifolds, air compressor, humidifier and valves. Membrane water conversion and N2 crossover were simultaneously considered in the stack component model. Based on the system-level model, the output voltage and water content of the PEMFC and the compressor power consumption at various currents and ambient pressures were investigated. Additionally, the dynamic behaviors of the cell voltage, its water content, and system hydrogen utilization rate were predicted for two legislated driving cycles-the New European Driving Cycle (NEDC) and the Worldwide Harmonized Light Vehicle Test Procedure (WLTP). The fuel cell voltage fluctuation owing to the anode purge occurred with an increase in the load current. Increasing the ambient pressure increased decay rate and recovery rate of the cell voltage, improved membrane hydration, and lowered the compressor power consumption. For the variable loads of the NEDC and WLTP, the fuel cell voltage and power fluctuated significantly. The membrane water content was controlled by the current in the low-current zone (i < 0.5 A cm-2) and was dominated by the high airflow in the high-current zone (i > 0.9 A cm-2). In the medium-current zone (0.5 A cm-2 < i < 0.9 A cm-2), the membrane water was saturated. The water vapor exhibited a dynamic behavior similar to that of the membrane water; the behavior fluctuated in low and high current zones and stabilized in the medium current zone. The liquid water fluctuated significantly in each current zone of the NEDC and WLTP. Additionally, the H2 utilization rates under NEDC and WLTP were greater than 99%. The developed global system model helps to understand the transient behaviors of a DEAmode PEMFC system and improves the system responsibility for fuel cell system design and development.

Operating Performance and Energy Flow Modeling for a Hundred-Kilowatt Proton Exchange Membrane Fuel Cell Stack Test System

The Design and Development of a PEMFC Testing System

Multi-Dimensional Performance Evaluation and Energy Analysis of Proton Exchange Membrane Water Electrolyzer

Comprehensive performance assessment and multi-objective optimization of high-power proton exchange membrane fuel cell system under variable load

Thermodynamic Modeling and Exergy Analysis of Proton Exchange Membrane Fuel Cell Power System

Thermodynamic Modeling and Performance Analysis of Vehicular High-Temperature Proton Exchange Membrane Fuel Cell System

A single-phase, non-isothermal model for PEM fuel cells

Simulation and Analysis of Steady State Characteristics of Hundred Kilowatt Proton Exchange Membrane Fuel Cell Combined Heat and Power System Based on Hydrogen Production from Natural Gas

A Comprehensive System-Level Model for Performance Evaluation of Proton Exchange Membrane Fuel Cell System with Dead-Ended Anode Mode

Enhanced Understanding of Electrothermal Dynamics Kinetic Behavior for Commercial-Size PEM Fuel Cells Based on Impedance and Distributed Temperature Measurement

Technological and Engineering Design of a Megawatt Proton Exchange Membrane Fuel Cell System

A model predicting performance of proton exchange membrane fuel cell stack thermal systems

Performance evaluation on thermodynamics-economy-environment of PEMFC vehicle power system under dynamic condition

Illustrative Case Study on the Performance and Optimization of Proton Exchange Membrane Fuel Cell

Modeling And Simulation Of A Modern Pem Fuel Cell System

Optimum Design and Performance Simulation of a Multi-Device Integrated System Based on a Proton Exchange Membrane Fuel Cell

Numerical Simulation of the Power Performance a Proton Exchange Membrane Fuel Cell under Dynamic Loading Conditions.

System-level modeling of proton exchange membrane fuel cell

Analytical and Experimental Investigations of A Proton Exchange Membrane Fuel Cell

Modeling and Analysis of HT-PEMFC System Based on Reformed Hydrogen

Performance evaluation and parametric optimization of a proton exchange membrane fuel cell/heat-driven heat pump hybrid system