Abstract:Heat integration and process optimization for the hydrogen production units of 1kW low-temperature proton exchange membrane fuel cells (LT-PEMFCs) were studied. Hydrogen is produced from methane in a process consisting of a steam methane reforming reaction (SMR), a high-temperature water–gas shift reaction (HWGS), a low-temperature water–gas shift reaction (LWGS), and a preferential oxidation reaction (PROX). Using commercial Aspen Plus® software, the process was designed and simulated with the objective of energy recovery. Furthermore, the unit operation parameters were discussed based on the mass/heat balances. Pinch analysis was applied for heat integration and process optimization to improve the energy recovery level of the hydrogen production system. By integrating system heating, a maximum energy recovery network (MER) and also a relaxed network were developed. The efficiencies of the hydrogen production systems designed with these MER and relaxed networks were 84.3% and 80.1%, respectively. Compared with the MER design, the relaxed network greatly simplifies the hydrogen production process and reduces the exchanger number from 18 to 9. The penalty in terms of power for relaxation is 120W. Sensitivity analysis shows that heat loss and the steam-to-carbon (S/C) ratio are the primary factors influencing the system efficiency, i.e., a 5% heat loss may result in a 7% efficiency drop, and increasing the S/C ratio from 2.5 to 3.0 may result in a 2.5% efficiency drop. The conversion of methane (XCH4) and the relative deviation from chemical equilibrium for the WGS reactions (both HWGS and LWGS) are secondary factors: efficiency drops 3.5% at XCH4=0.8 and at 0.9 of the WGS equilibrium, compared with equilibrium conditions. Finally, the minimum pinch temperature difference (ΔTmin) and reaction temperatures have little impact on system efficiency. Therefore, the device insulation and catalyst performance are very important for system performance.

Simulation and Analysis of Steady State Characteristics of Hundred Kilowatt Proton Exchange Membrane Fuel Cell Combined Heat and Power System Based on Hydrogen Production from Natural Gas

Thermodynamic Modeling and Exergy Analysis of Proton Exchange Membrane Fuel Cell Power System

A single-phase, non-isothermal model for PEM fuel cells

Operating Performance and Energy Flow Modeling for a Hundred-Kilowatt Proton Exchange Membrane Fuel Cell Stack Test System

Modeling and Analysis of HT-PEMFC System Based on Reformed Hydrogen

Comprehensive performance assessment and multi-objective optimization of high-power proton exchange membrane fuel cell system under variable load

Thermodynamic Modeling and Performance Analysis of Vehicular High-Temperature Proton Exchange Membrane Fuel Cell System

Modelling and Simulation System of Proton Exchange Membrane Fuel Cell

A model predicting performance of proton exchange membrane fuel cell stack thermal systems

Modeling and Techno-Economic Analysis of the Heat Pump-Integrated PEMFC-based Micro-Chp System

Performance, Efficiency, and Flexibility Analysis of a High-Temperature Proton Exchange Membrane Fuel Cell-Based Micro-Combined Heat-and-Power System with Intensification of the Steam Methane Reforming Step by Using a Millistructured Reactor

Modeling and Simulation of a Residential-Based PEMFC-CHP System

Technological and Engineering Design of a Megawatt Proton Exchange Membrane Fuel Cell System

System-level modeling of proton exchange membrane fuel cell

Coupling of high-temperature proton exchange membrane fuel cells with methanol steam reforming: Modeling and simulation for an integrated coupled for power generation system

A 10Kw-Scale Distributed Power Plant of Natural Gas-Proton Exchange Membrane Fuel Cell

Heat Integration and Optimization of Hydrogen Production for a 1 Kw Low-Temperature Proton Exchange Membrane Fuel Cell

Performance evaluation on thermodynamics-economy-environment of PEMFC vehicle power system under dynamic condition

Comprehensive performance analysis and optimization for PEMFC-heat pump combined system considering dual heat source

Thermal analysis of high-temperature proton exchange membrane fuel cell integrated compression-assisted absorption heat pump system

Effects of Operating Conditions on Water and Heat Management by a Transient Multi-Dimensional PEMFC System Model