Abstract:Die attach is one of the major processes that may induce unwanted stresses and deformations into micro-electro-mechanical systems (MEMS). The thermo-elastic coupling between the die and package may affect the performance of MEMS under various temperature loads, causing unreasonable effects of the output signal, such as zero offset, temperature coefficient of offset (TCO), nonlinearity, ununiformity and hysteresis, etc. A complete characterization of these effects is critical for a more reliable design. This work presents experimental studies of the temperature effects on the dynamic properties of MEMS. Microbridges and strain gauges with different dimensions were used as test structures. They were surface-micromachined on test chips and the chips were die attached on organic laminate substrates using epoxy bonding as well as tape adhering. The material and dimension of the substrate were specially defined to amplify the magnitude of the coupled deformation for the convenience of investigation. Modal frequencies of the microbridges under a set of controlled environmental temperature before and after die attach were measured using a laser Doppler vibrometer system. The average initial residual strain was also measured from the strain gauges to help analyze the dynamic behavior. Nonlinear TCO of the frequencies were observed to be as large as 2,500–5,000 ppm for the epoxy-bonded samples, in contrast with much smaller values for the tape-adhered and unpackaged ones. The frequencies recovered to their original values beyond the curing temperature of the epoxy. A distributed feature was also observed in frequencies of the microbridges with the same length but at different locations of the chip with a maximum relative difference of 20%. The process of thermal cycling and wire bonding was also applied to the samples and caused tender shifts of the frequencies. The experiments reveal major factors that are related to the temperature effects of die attached MEMS and the results are useful for improving the reliability of a package–device co-design.

Prestressing-Based Thermal Budget Study of MEMS Cantilever and Its Application in Package Processes

Thermal stress of MOEMS Accelerometers Based on Grating Interferometric cavity

Investigation of Thermal Creep in Metal-Based MEMS Cantilevers

Reliability Research on the Thermal Deformation and Thermal Stress of the Metal Packaging with Low Resistance and High Electric Current

Reliability Research on the Thermal Deformation and Stress of Metal Packaging with Low-Resistance Leads

Modeling and Measurement of Thermal–Mechanical-Stress-Creep Effect for RF MEMS Switch Up to 200 °C

Structural Optimization and Mechanical Simulation of MEMS Thin-Film Getter–Heater Unit

Monotonic and fatigue testing of spring-bridged freestanding microbeams application for MEMS

Coupling Effect of Strain Gradient Strengthening and Thermal Softening on the Microscale Plastic Behavior of Metallic Materials

Processes-based Multistep Simulation of Thermal- mechanical Reliability of a 3D-TSV MEMS

Influence of environmental temperature on the dynamic properties of a die attached MEMS device

Temperature Effects in Packaged RF MEMS Switches with Optimized Gold Electroplating Process

Variation of MEMS Thin Film Device Parameters under the Influence of Thermal Stresses

Finite element modeling and analysis of ultrasonic bonding process of thick aluminum wires for power electronic packaging

Optimization and Fabrication of MEMS suspended structures for nanoscale thermoelectric devices

Residual Stress and Warping Analysis of the Nano-Silver Pressureless Sintering Process in SiC Power Device Packaging

Methods for precisely controlling the residual stress and temperature coefficient of the frequency of a MEMS resonator based on an AlN cavity silicon-on-insulator platform

Temperature and Process Dependent Material Characterization and Multiscale Stress Evolution Analysis for Performance and Reliability Management under Chip Package Interaction

Reliability Inspection for Bilayer Nanosilver Paste Ensemble Pressureless Sintered Embedded Cooling SiC Power Module

A thermal activation based constitutive model for the dynamic deformation of AA5083 processed by large-scale equal-channel angular pressing

Determining the thermal expansion coefficient of thin films for a CMOS MEMS process using test cantilevers