Abstract:Piezoelectric wafer active sensors (PWAS) have been proven a valuable tool in structural health monitoring. Piezoelectric wafer active sensors are able to send and receive guided Lamb/Rayleigh waves that scan the structure and detect the presence of incipient cracks and structural damage. In-situ thin-film active sensor deposition can eliminate the bonding layer to improve the durability issue and reduce the acoustic impedance mismatch. Ferroelectric thin films have been shown to have piezoelectric properties that are close to those of single-crystal ferroelectrics but the fabrication of ferroelectric thin films on structural materials (steel, aluminum, titanium, etc.) has not been yet attempted. In this work, in-situ fabrication method of piezoelectric thin-film active sensors arrays was developed using the nano technology approach. Specification for the piezoelectric thin-film active sensors arrays was based on electro-mechanical-acoustical model. Ferroelectric BaTiO3 (BTO) thin films were successfully deposited on Ni tapes by pulsed laser deposition under the optimal synthesis conditions. Microstructural studies by X-ray diffractometer and transmission electron microscopy reveal that the as-grown BTO thin films have the nanopillar structures with an average size of approximately 80 nm in diameter and the good interface structures with no inter-diffusion or reaction. The dielectric and ferroelectric property measurements exhibit that the BTO films have a relatively large dielectric constant, a small dielectric loss, and an extremely large piezoelectric response with a symmetric hysteresis loop. The research objective is to develop the fabrication and optimum design of thin-film active sensor arrays for structural health monitoring applications. The short wavelengths of the micro phased arrays will permit the phased-array imaging of smaller parts and smaller damage than is currently not possible with existing technology.

Bearing Fault Monitoring Based on Flexible Piezoelectric Accelerometer

Ferroelectric Thin-Film Active Sensors for Structural Health Monitoring

Intelligent Diagnosis Research of Piezoelectric Accelerometer Sensors Fault

MEMS high-frequency accelerometers for mechanical fault monitoring

Research of a Real-time Test System with PVDF Piezoelectric-film Sensors for Measurement of Dynamic Oil Film Pressure of Sliding Bearings

A High-Performance Multi-Beam Microaccelerometer for Vibration Monitoring in Intelligent Manufacturing Equipment

Bearing Race Fault Detection Using an Optomechanical Micro-Resonator

Design of a Piezoelectric Accelerometer with High Sensitivity and Low Transverse Effect

Development of Piezoresistive Flexible Sensor with Dual-height Cylindrical Microstructure Surfaces to Achieve Vehicle Vibration Monitoring

Study on Noncontact Aviation Bearing Faults and Speed Monitoring

Multi-Flexure Piezoresistive Accelerometer for Vibration Detection

A piezoresistive micro-accelerometer with high frequency response and low transverse effect

An Automatic Bearing Fault Diagnosis Method Based On Characteristics Frequency Ratio

Simulation research on bearing lubricating micro-jet driven by piezoelectric ceramic

Evaluation of the Diagnostic Sensitivity of Digital Vibration Sensors Based on Capacitive MEMS Accelerometers

Impact Detection Based On in-Situ Direct Writing Piezoelectric Polymer Sensor Array

Modeling and Characterization of a Novel In-Plane Dual-Axis MEMS Accelerometer Based on Self-Support Piezoresistive Beam

Optical fiber vibration sensor for bearing fault detection based on Sagnac interferometer

Flexible, Equipment-Wearable Piezoelectric Sensor with Piezoelectricity Calibration Enabled by In-Situ Temperature Self-Sensing.

Research on Bearing Fault Monitoring Technology Based on the Acoustic Array in Working Environment

Smart Sensor-Based Monitoring Technology for Machinery Fault Detection