Abstract:Hydropower has been the leading renewable source and cheapest ways to generate electrical energy in the world. In recent years, there has been a major upsurge in the hydropower development because of the use of pump as turbine (PAT). However, the operational reliability of a PAT is greatly affected by the unsteady flow fields; therefore, it is important to examine the unsteady flow behavior which can be used as a reference to reduce the noise, vibration, and cavitation performance for centrifugal pumps working as turbines. Thus, the objective of this study was to evaluate the unsteady flow fields by analyzing the distribution of the pressure pulsations using both numerical and experimental measurements in a PAT operating in pump mode. Firstly, the three‐dimensional (3D) unsteady flow equations were solved using SST <i>k‐</i>ω turbulence model during the numerical calculations. Secondly, the numerical results of the hydraulic pump performance were validated by the experimental measurements for numerical accuracy. Lastly, pressure transducers are positioned at certain monitoring points to measure the pressure in the PAT investigated. The numerical and experimental results show that the main frequency of the pressure pulsation is equal to the blade frequency, and as it deviates from the design operating condition, the magnitude of pressure pulsation intensifies. Furthermore, the impeller eye marked the lowest pressure coefficients especially at the design condition and makes it highly susceptible to cavitation. High pressure coefficients were obviously seen at the pressure side on the blade surface closer to the trailing edge at all studied operating conditions. Meanwhile, the rotor‐stator interaction generated the highest pressure pulsation distribution at the volute tongue. Thus, modification of the volute tongue is an optimal approach of reducing the pressure pulsation intensity in the volute and pump as a whole.

Study of Axial Hydraulic Thrust and Radial Force Characteristics of a Variable Speed Pump-Turbine Unit

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Numerical Analysis on the Hydraulic Thrust and Dynamic Response Characteristics of a Turbine Pump

Hydraulic Characterization of Variable-Speed Pump Turbine under Typical Pumping Modes

Analysis of Flow and Runner Dynamic Response Characteristics under Pump Conditions of Variable-Speed Pump Turbine

Effect of Rotational Speed on Pressure Pulsation Characteristics of Variable-Speed Pump Turbine Unit in Turbine Mode

Vibration of Variable Speed Pump-Turbine in Turbine Operating Range: Simulation by CFD+FEM

Performance analysis and experimental verification of hydraulic driven axial flow pumps

Transient Characteristic Analysis of Variable Frequency Speed Regulation of Axial Flow Pump

Numerical Study of Hydraulic Axial Force of Prototype Pump-Turbine Pump Mode's Stop with Power Down

Research on the Flow Characteristics in the Gap of a Variable-Speed Pump-Turbine in Pump Mode

Numerical Investigation of Guide Vane Hydraulic Torque Characteristics of a Pump Turbine in Pump Mode

Numerical investigation of unsteady pressure pulsation characteristics in an ultra-low specific-speed centrifugal pump as a turbine

Effect of Speed Linear Decrease on Internal Flow Characteristics and Pressure Pulsations of Variable-Speed Pump Turbine in Turbine Mode

Regulation Characteristics and Load Optimization of Pump-Turbine in Variable-Speed Operation

Numerical Study on the Flow and Structural Characteristics of a Large High Head Prototype Pump-Turbine under Different Operating Conditions

Numerical Simulation and Computational Flow Characterization Analyses of Centrifugal Pump Operating as Turbine

Numerical Analysis of Flow Characteristics in Impeller-Guide Vane Hydraulic Coupling Zone of an Axial-Flow Pump as Turbine Device

Internal Flow Phenomena of Two-Way Contra-Rotating Axial Flow Pump-Turbine in Pump Mode under Variable Speed

Investigations on Pressure Fluctuations in the S-Shaped Region of a Pump–Turbine