Abstract:A radio frequency (RF) pulse compressor had been designed for the X-band (11.424 GHz) high power test stands at the Accelerator Laboratory of Tsinghua University. It is a SLED-I type pulse compressor, which uses a high quality factor corrugated circular cavity to store the RF power. An RF polarizer couples two quadrature modes into the cavity so that the pulse compressor needs only one cavity. The cavity implements HE1-1-14 mode, with the Q0 of 115,000 and the coupling factor ( ) of 3.23. The design and the microwave measurement before brazing of this pulse compressor are presented in this paper. INTRODUCTION RF pulse compressors enhance the RF peak power at the expense of shortening pulse widths. Passive pulse compressors, rather than active ones, have been widely used due to better stability and easier fabrication. The SLAC energy doubler (SLED-I), the resonant delay line pulse compressor (SLED-II) and the barrel open cavity (BOC) have been proposed and developed as three main types of passive pulse compression systems with different RF components. The SLED-I and SLED-II store the RF pulse in a resonant cavity or a delay line and output a decaying exponential or a flat pulse respectively, while the BOC type houses a whispering galley mode of high unloaded quality factor (Q0) in a more complicated cavity structure [1-3]. Typical pulse compression systems consist of two identical cavities or delay lines and a 3-dB coupler for isolation. A compact RF pulse compression system with one spherical cavity and an RF polarizer has been designed and tested at SLAC [4]. At Tsinghua University, the Tsinghua Thomson-scattering X-ray Source (TTX) upgrade project plans to add two X-band linacs in the injector and boost the electron beam from the current 50 MeV to 150 MeV, as shown in Fig. 1. To feed these two structures, a SLED-I type pulse compressor is required to compress the pulse width from 1.5 μs to 100 ns and generate more than 250 MW peak power from a 50 MW klystron at the frequency of 11.424 GHz.

The X-Band Pulse Compressor for Tsinghua Thomson Scattering X-Ray Source

Design and Measurement of the X-Band Pulse Compressor for TTX

Development of Tsinghua X-Band High Power Test Facility

Development of a S-Band Pulse Compressor

X -Band Two-Stage Rf Pulse Compression System with Correction Cavity Chain

Design of an X-Band Photocathode for Tsinghua Thomson Scattering X-Ray Source

Design of a Pulse Transformer for X-band Klystron

A Compact X-Band Microwave Pulse Compressor Using a Corrugated Cylindrical Cavity

Development of an S-band spherical pulse compressor

The RF Design of a Compact, High Power Pulse Compressor with a Flat Output Pulse

Rf Design of a Pulse Compressor with Correction Cavity Chain for Klystron-Based Compact Linear Collider

A simulation study of Tsinghua Thomson scattering X ray source

Soft X-Ray Generation Experiment at the Tsinghua Thomson Scattering X-Ray Source

Researches of Thomson scattering ultra-short pulse X-ray source at Tsinghua University

Non-perturbing THz Generation at the Tsinghua University Accelerator Laboratory 31 MeV Electron Beamline.

Development of an L-band Continuous-Wave Buncher at Tsinghua University

Generation of First Hard X-ray Pulse at Tsinghua Thomson Scattering X-ray Source.

Towards a compact all optical terahertz-driven electron source at Tsinghua University

Fabrication and high-power testing of an X-band high-power phase shifter for the very compact inverse Compton scattering gamma-ray source

A 3-Mev RFQ Accelerator for the Compact Pulsed Hadron Source at Tsinghua University

Design of A Source to Supply Ultra-Fast Electron and X-Ray Pulses